iCAM50x Quick Start Guide

iCAM50x Quick Start Guide
Bad Picture
right to left
To indicate a bad picture
Voice record function
has been taken, the three
lights flash IN SEQUENCE
Picture quality is indicated by the LEDs (below). All
three times from right toAllows a voice message
pictures are stored as occasionally conditions mean
to be assoicated
left ie. red, blue, green,
it is not possible to get a perfect picture and a poor
with a picture. Press
red, itblue,
green and red,record button - blue
one is better than no picture. However
is strongly
green.
recommended that another pictureblue,
is taken.
LED indicates feature
Picture quality
Good picture
All three
lights flash
TOGETHER
Vision Technologies
enabled. Take a picture
in the usual way but
CONTINUE to hold the
picture button.
To indicate a
good picture has
When the blue light
been taken, all
flashes, record your
To indicate
a good picture
three
lights flash
message and release
TOGETHER
has been three
taken, all three
picture button when
times
and
youTOGETHER
will
lights
flash
finished.
hear
a beep
three
times and you will
Good Picture
The three
lights flash
IN SEQUENCE
right to left
ON OFF
FLASH
hear a beep.
Downloading pictures
RECORD
Bad Picture
To indicate a bad picture
has been taken, the three
lights flash IN SEQUENCE
three times from right to
left ie. red, blue, green,
red, blue, green and red,
blue, green.
Bad picture
Simply turn on the iCAM501U, connect the
The three
To indicate a bad
USB cable to a Windows 7 /Vista or XP PC and
lights flash
IN SEQUENCE picture, the three
follow the on-screen instructions.
To indicate a bad picture
right to left lights flash IN
Bad Picture
has been taken,
SEQUENCE
three the three
lights
flash
IN to
SEQUENCE
times from right
three
times
from
right to
left i.e. red, blue,
left
ie.
red,
blue,
green,
green etc.
FLASH
RECORD
This quick start guide
explains how to use
the camera and its
various functions. For
Safety Instructions
please refer to
intructions enclosed
with your iCAM50x.
•
•
•
•
•
Using the flash
ON OFF
Quick Start Guide
Package Contents
red, blue, green and red,
blue, green.
Press the flash button
and the red LED will start
to flash. The LED will
become solid indicating
the flash is ready for use.
The green LED flashing
slowly indicates low battery.
Once enabled - the flash
function is automatic i.e.will
only operate in low light
conditions
iCAM 50x
iCAM50x camera
Safety Instructions
Two approved AA batteries
Internal USB lead
1 lanyard
Plug into
any PC
via the
USB port
Tel +44 (0)845 277 5000
www.extronics.com
iCAM50x
Inserting the battery
Preparing for use
The iCAM50x is shipped with a protective film
fitted to the front and rear windows. This should be
carefully removed before use.
Switching the camera
on and off
To change or install the batteries
in the iCAM50x, turn the screw
as indicated below to remove the
cover
Green LED will flash
rapidly for ~10
seconds & the Blue
and Red LED will flash
briefly. The Green
LED then goes solid
when ready. The
green LED flashing
slowly indicates a low
battery level
Open the
camera back
with a coin
The iCAM50x may be used with the protective
rubber overboot supplied. Only the rubber overboot
supplied by Extronics should be used as it is made
from electrostatically-dissipative material.
ON OFF
FLASH
RECORD
Remember - Remove ALL plastic coverings from
the lens & viewfinder before taking pictures
Hold the
FLASH &
RECORD
buttons
together
Viewfinder
Function Lights
Flash Button
Picture
ShutterButton
Button
Record Button
NB. When pressed
simultaneously the
Record and Flash
Buttons are also
used to switch the
camera on and off.
Coin operated
access to battery
compartment
and USB port
Taking a picture
Install the batteries in the correct
orientation (indicated on the
enclosure) and close the lid
again. PLEASE NOTE: Only those
batteries listed in the Safety
Instructions can be used.
1. Press and hold
picture button until
green LED starts
flashing rapidly.
2. Wait for green LED
to stop flashing before
moving
USB Port
ON OFF
FLASH
Press and
hold the
large square
button
Battery
compartment
RECORD
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising