Installation Instructions Description and Form I-F-CH1 (Version .1)

Installation Instructions  Description and Form I-F-CH1 (Version .1)
Form I-F-CH1 (Version .1)
Obsoletes Installation Form RZ/NA I-F-SW
Installation Instructions
Applies to: Manual Summer/Winter Fan Switch
Option CH1, for Models F & FE 25-400
Description and
Application
The optional summer/winter switch is designed to provide manual control of fan
operation.
The option package includes:
Option CH1
Manual Summer/Winter
Fan Switch
Qty
Option Package P/N
General
F and FE
25-400
P/N
98485
Summer/Winter Switch with pull cord
1
98148
Instruction Sheet
1
98294
Cautions and Warnings
There are warning labels on the unit, on the front page, and throughout this manual.
For your safety, comply with all warnings during installation, operation, and service of
this system. Definitions of the hazard intensity levels of the cautions, warnings, and
dangers are shown below.
HAZARD INTENSITY LEVELS
1.DANGER: Failure to comply will result in severe personal
injury or death and/or property damage.
2.WARNING: Failure to comply could result in severe personal
injury or death and/or property damage.
3.CAUTION: Failure to comply could result in minor personal
injury and/or property damage.
Installation
Instructions
Installation should be done by a qualified agency in accordance with these instructions
and in compliance with all codes and requirements of authorities having jurisdiction.
Tools Required: One 5/16" Nut Driver.
1. If the heater is installed, turn off the gas and turn off the electrical power.
2. Remove the outer side panel on the left side of the heater (left when facing the
back of the heater), exposing the inner side panel and wiring.
3. On the rear edge of the inner side panel, locate a 1/2"diameter hole (See Figure
1 shown on page 2). Insert the chain and the front of the switch through the hole.
Arrange the knurled nut as shown in Figure 1 and tighten firmly by hand.
4. Wire the summer/winter switch as shown on the specific wiring diagram included
with your heater or refer to the general diagram shown on page 2.
5. Replace the outer side panel as shown in Figure 2 on page 2.
6. Install the pull cord on the summer/winter switch.
7. If the heater is installed, turn on the electric power and the gas and re-light,
following the instructions on the heater. Check the operation of the summer/winter
switch. CHECK FOR PROPER OPERATION OF ALL SAFETY FEATURES.
If the heater is not installed, be sure to support the bottom with plywood or other
appropriate material. Follow the installation instructions provided with the heater
and check for proper operation of the summer/winter switch.
Form I-F-CH1 (Version .2), PN 98294R2, Page1
Left
Inner
Side
Panel
Switch
Inner
Nut
Outer
Knurled
Nut
Place chain through
hole first.
1/2”diameter hole
Figure 1
Manual Summer/
Winter Fan Switch
Figure 2
Wiring Diagram - Option CH1, Manual Summer/
Winter Switch on Fan-Type Unit Heater
www.ReznorHVAC.com; (800) 695-1901
©2014 Reznor, LLC. All rights reserved.
Trademark Note: Reznor® is registered in at least the United States.
Form I-F-CH1 (Version .2), PN 98294R2, Page2
0514 (Serial No. Date Code BNE) Form I-F-CH1 (Version .2), PN 98294R2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising