7 3 4 3
7343
BAHN SPARK PLUG-HEAD BOLT COVERS, CHROME
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING
THE CONTENTS DESCRIBED HEREIN CAN RESULT IN POTENTIAL DEATH OR SERIOUS INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING
THE CONTENTS DESCRIBED HEREIN CAN RESULT IN MINOR
OR MODERATE POTENTIAL INJURY.
This indication alerts you to the fact that ignoring the contents described herein may negatively affect product performance and functionality or damage the product itself or
the product to which it is being attached.
MAKE SURE THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:
1
1
1
1
Front Head Bolt Cover, Chrome
Rear Head Bolt Cover, Chrome
Hardware Kit containing:
4
Mounting Caps
8
#10-32 X 1/4” Set Screws
4
#10-32 X 3/8” Socket Head Cap Screws
Installation Instructions
YOU WILL ALSO NEED:
Set of hex wrenches
These installation instructions contain important information. Ensure that the end user receives this copy and is
aw are of its importance for future reference.
STEP 1
Read and understand all steps in the instructions before starting the installation. Park the motorcycle on
a hard, level surface and turn IGN OFF. Allow the engine and exhaust system to cool.
YOU WILL BE WORKING AROUND THE ENGINE AND EXHAUST
SYSTEM DURING INSTALLATION. ENSURE THAT THE ENGINE
AND EXHAUST SYSTEM HAVE FULLY COOLED TO PREVENT
INJURY.
WORKING AROUND THE SHARP EDGES OF THE CYLINDERHEAD FINS EXPOSES YOUR HANDS TO INJURY. WEAR PROTECTIVE GLOVES TO PREVENT SERIOUS INJURY.
7343-12HD-0215
-cont.-
7343
STEP 2
BAHN SPARK PLUG-HEAD BOLT COVERS, CHROME
Refer to PIC 1. Loosely install two of the included Set
PIC 1
Screws into each of the Mounting Caps. Install one of the
Mounting Caps on each headbolt. Push down on the Caps
to hold them tight against the headbolts, then tighten the
Set Screws securely.
STEP 3
Refer to PIC 2. Determine the Front and Rear Bahn Spark
SECURE MOUNTING CAPS
WITH THE SET SCREWS
Plug Head Bolt Covers. The Covers are marked front and
rear on the underside.
STEP 4
Refer to PIC 3. Place the Front Bahn
PIC 2
Spark Plug Head Bolt Cover over the
front Mounting Caps. Secure the Cover to
the Caps with the included #10 Socket
Head Cap Screws; leave the screws
loose until both have been started in their threads.
STEP 5
Holding the cover centered in the spark plug opening and
PIC 3
SECURE THE COVERS
WITH THE SOCKET
HEAD SCREWS
sitting level to the head, tighten the Socket Head Cap
Screws securely.
STEP 6
NOTE:
Repeat STEPS 4 and 5 for the rear cover.
Disconnecting the spark plug wires may
ease installation.
It is not necessary to remove the Covers
when replacing spark plugs.
It is the end user’s responsibility to ensure that all of the
fasteners (including pre-assembled) are tightened before operation of the motorcycle. Küryakyn w ill not provide w arranty
coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and
maintenance are required on all fasteners.
2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising