KN0810m Castaldo Plast O Wax SDS

KN0810m Castaldo Plast O Wax SDS
Castaldo®
Safety Data Sheet
Plast-O-Wax® Jewelry Injection Wax
SDS Revision Date:
12/05/2014
1. Identification of the substance/mixture and of the company/undertaking
1.1. Product identifier
Product Identity
Castaldo® Plast-O-Wax® Jewelry Injection Wax
Alternate Names
Castaldo® Plast-O-Wax® Jewelry Injection Wax
1.2. Relevant identified uses of the substance or mixture and uses advised against
Intended use
See Technical Data Sheet.
Application Method
See Technical Data Sheet.
1.3. Details of the supplier of the safety data sheet
Company Name
F. E. Knight Inc.
120 Constitution Blvd.,
Franklin, MA 02038. USA
Emergency
24 hour Emergency Telephone No.
Chem-Tel: 1-800-255-3924 or 617-969-5399
Customer Service: F. E. Knight Inc.
508-520-1666
2. Hazard identification of the product
2.1. Classification of the substance or mixture
No applicable GHS categories.
2.2. Label elements
Using the Toxicity Data listed in section 11 and 12 the product is labeled as follows.
No applicable GHS categories.
[Prevention]:
No GHS prevention statements
[Response]:
No GHS response statements
[Storage]:
Page 1 of 8
Castaldo®
Safety Data Sheet
Plast-O-Wax® Jewelry Injection Wax
SDS Revision Date:
12/05/2014
No GHS storage statements
[Disposal]:
No GHS disposal statements
3. Composition/information on ingredients
There are no ingredients in this product which are classified as hazardous.
4. First aid measures
4.1. Description of first aid measures
General
In all cases of doubt, or when symptoms persist, seek medical attention.
Never give anything by mouth to an unconscious person.
Inhalation
Remove to fresh air, keep patient warm and at rest. If breathing is irregular or
stopped, give artificial respiration. If unconscious place in the recovery position
and obtain immediate medical attention. Give nothing by mouth.
Eyes
Irrigate copiously with clean water for at least 15 minutes, holding the eyelids
apart and seek medical attention.
Skin
Exposure to fumes, vapors or smoke of thermally degraded product can result in
irritation to skin. Direct contact with molten material may cause injury and burns.
For burns apply running water to the injured area for 15 minutes. Do not attempt
to remove any material bonded to the skin. Seek medical attention immediately.
Ingestion
If swallowed obtain immediate medical attention. Keep at rest. Do NOT induce
vomiting.
4.2. Most important symptoms and effects, both acute and delayed
Overview
Eye Contact: Contact with solid material may cause irritation. Direct contact with
molten wax to the eye may cause thermal burns. Exposure to fumes may cause
eye irritation.
Skin Contact: No danger at room temperature. Direct contact with molten wax to
the skin may cause thermal burns.
Inhalation: Molten wax fumes may cause respiratory discomfort and irritation.
Ingestion: Material is essentially inert and non-toxic. May cause gastrointestinal
irritation, nausea, vomiting and diarrhea if ingested in large quantities.
5. Fire-fighting measures
5.1. Extinguishing media
Recommended extinguishing media; alcohol resistant foam, CO2, powder or water fog. Do not use; water
jet.
5.2. Special hazards arising from the substance or mixture
Hazardous decomposition: Upon decomposition, this product emits carbon monoxide, carbon dioxide
and/or low molecular weight hydrocarbons.
5.3. Advice for fire-fighters
Page 2 of 8
Castaldo®
Safety Data Sheet
Plast-O-Wax® Jewelry Injection Wax
SDS Revision Date:
12/05/2014
This product will burn if involved in a fire. Do not use water on molten product to avoid splattering and
spreading of fire. Wear full firefighting gear and self-contained breathing apparatus.
ERG Guide No.
---6. Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Put on appropriate personal protective equipment (see section 8).
6.2. Environmental precautions
Use good personal hygiene practices. Wash hands before eating, drinking, smoking or using toilet.
Promptly remove soiled clothing and wash thoroughly before reuse.
6.3. Methods and material for containment and cleaning up
Treat as a thermoplastic. With molten spills, allow the material to cool and solidify. Keep material out of
sewers and water streams by diking or impounding. Recover and place into appropriate containers for
salvage or disposal according to Local, State and Federal regulations.
7. Handling and storage
7.1. Precautions for safe handling
Avoid contact with skin and eyes. Avoid contact with molten material. Wash thoroughly after handling.
Avoid breathing fumes if used at high temperatures. Use in adequate ventilation.
7.2. Conditions for safe storage, including any incompatibilities
Incompatible materials: Strong oxidizing agents (i.e. peroxides, chlorine).
Store sealed containers in a cool dry place away from heat and direct sunlight.
7.3. Specific end use(s)
No data available.
8. Exposure controls and personal protection
8.1. Control parameters
There are no ingredients in this product which are classified as hazardous.
8.2. Exposure
controls
Respiratory
Eyes
If workers are exposed to concentrations above the exposure limit they must use
the appropriate, certified respirators.
Protective safety glasses with side shields recommended.
Skin
Proper protective splash resistant clothing, thermal gloves, splash resistant shoes
Engineering Controls Provide adequate ventilation. Where reasonably practicable this should be
achieved by the use of local exhaust ventilation and good general extraction. If
these are not sufficient to maintain concentrations of particulates and any vapor
below occupational exposure limits suitable respiratory protection must be worn.
Page 3 of 8
Castaldo®
Safety Data Sheet
Plast-O-Wax® Jewelry Injection Wax
SDS Revision Date:
12/05/2014
Other Work Practices This material will be utilized in molten form. Proper protective splash resistant
clothing, thermal gloves, splash resistant shoes, and eye shields should be worn
to prevent injury. Use molten material in well ventilated areas. When working in
confined areas, use of appropriate respiratory gear is recommended. Use good
personal hygiene practices. Wash hands before eating, drinking, smoking or using
toilet. Promptly remove soiled clothing and wash thoroughly before reuse.
See section 2 for further details. - [Prevention]:
9. Physical and chemical properties
Appearance
Blue flakes solid @25C/77F
Odor
No
Odor threshold
Not Measured
pH
NA
Melting point / freezing point
58-80 C
Initial boiling point and boiling range
NA
Flash Point
420 F (COC)
Evaporation rate (Ether = 1)
NA
Flammability (solid, gas)
Not Applicable
Upper/lower flammability or explosive limits
Lower Explosive Limit: NA
Upper Explosive Limit: NA
Vapor pressure (Pa)
NA
Vapor Density
NA
Specific Gravity
< 1 (H2O=1)
Solubility in Water
Not Measured
Partition coefficient n-octanol/water (Log Kow) Not Measured
Auto-ignition temperature
NA
Decomposition temperature
NA
Viscosity (cSt)
NA
VOC %
NA
% Volatile
Negligible
Solibility in organic solvent
Soluble
9.2. Other information
No other relevant information.
10. Stability and reactivity
10.1. Reactivity
Page 4 of 8
Castaldo®
Safety Data Sheet
Plast-O-Wax® Jewelry Injection Wax
SDS Revision Date:
12/05/2014
Hazardous Polymerization will not occur.
10.2. Chemical stability
Stable under normal circumstances.
10.3. Possibility of hazardous reactions
No data available.
10.4. Conditions to avoid
Excessive heat and open flame.
10.5. Incompatible materials
Strong oxidizing agents (i.e. peroxides, chlorine).
10.6. Hazardous decomposition products
Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or low molecular weight
hydrocarbons.
11. Toxicological information
Acute toxicity
There are no ingredients in this product which are classified as hazardous.
Note: When no route specific LD50 data is available for an acute toxin, the converted acute toxicity point
estimate was used in the calculation of the product's ATE (Acute Toxicity Estimate).
Classification
Acute toxicity (oral)
Category
---
Hazard Description
Not Applicable
Acute toxicity (dermal)
---
Not Applicable
Acute toxicity (inhalation)
---
Not Applicable
Skin corrosion/irritation
---
Not Applicable
Serious eye damage/irritation
---
Not Applicable
Respiratory sensitization
---
Not Applicable
Skin sensitization
---
Not Applicable
Germ cell mutagenicity
---
Not Applicable
Carcinogenicity
---
Not Applicable
Reproductive toxicity
---
Not Applicable
STOT-single exposure
---
Not Applicable
STOT-repeated exposure
---
Not Applicable
Aspiration hazard
---
Not Applicable
Page 5 of 8
Castaldo®
Safety Data Sheet
Plast-O-Wax® Jewelry Injection Wax
SDS Revision Date:
12/05/2014
12. Ecological information
12.1. Toxicity
No additional information provided for this product. See Section 3 for chemical specific data.
Aquatic Ecotoxicity
There are no ingredients in this product which are classified as hazardous.
12.2. Persistence and degradability
There is no data available on the preparation itself.
12.3. Bioaccumulative potential
Not Measured
12.4. Mobility in soil
No data available.
12.5. Results of PBT and vPvB assessment
This product contains no PBT/vPvB chemicals.
12.6. Other adverse effects
No data available.
13. Disposal considerations
13.1. Waste treatment methods
Observe all federal, state and local regulations when disposing of this substance.
14. Transport information
14.1. UN number
DOT (Domestic Surface
Transportation)
Not Applicable
14.2. UN proper shipping Not Regulated
name
14.3. Transport hazard DOT Hazard Class: Not
class(es)
Applicable
14.4. Packing group
Not Applicable
IMO / IMDG (Ocean
Transportation)
Not Regulated
ICAO/IATA
Not Regulated
Not Regulated
IMDG: Not Applicable
Sub Class: Not
Applicable
Not Applicable
Air Class: Not
Applicable
14.5. Environmental hazards
IMDG
Marine Pollutant: No
14.6. Special precautions for user
Page 6 of 8
Not Regulated
Not Applicable
Castaldo®
Safety Data Sheet
Plast-O-Wax® Jewelry Injection Wax
SDS Revision Date:
12/05/2014
No further information
15. Regulatory information
Regulatory Overview The regulatory data in Section 15 is not intended to be all-inclusive, only selected
regulations are represented.
Toxic Substance
All components of this material are either listed or exempt from listing on the
Control Act ( TSCA) TSCA Inventory.
WHMIS Classification Not Regulated
US EPA Tier II
Hazards
Fire:No
Sudden Release of Pressure:No
Reactive:No
Immediate (Acute):No
Delayed (Chronic):No
EPCRA 311/312 Chemicals and RQs:
(No Product Ingredients Listed)
EPCRA 302 Extremely Hazardous :
(No Product Ingredients Listed)
EPCRA 313 Toxic Chemicals:
(No Product Ingredients Listed)
Proposition 65 - Carcinogens (>0.0%):
(No Product Ingredients Listed)
Proposition 65 - Developmental Toxins (>0.0%):
(No Product Ingredients Listed)
Proposition 65 - Female Repro Toxins (>0.0%):
(No Product Ingredients Listed)
Proposition 65 - Male Repro Toxins (>0.0%):
(No Product Ingredients Listed)
N.J. RTK Substances (>1%) :
(No Product Ingredients Listed)
Penn RTK Substances (>1%) :
(No Product Ingredients Listed)
16. Other information
Page 7 of 8
Castaldo®
Safety Data Sheet
Plast-O-Wax® Jewelry Injection Wax
SDS Revision Date:
12/05/2014
The information and recommendations contained herein are based upon data believed to be correct.
However, no guarantee or warranty of any kind, expressed or implied, is made with respect to the
information contained herein. We accept no responsibility and disclaim all liability for any harmful effects
which may be caused by exposure to our products. Customers/users of this product must comply with all
applicable health and safety laws, regulations, and orders.
The full text of the phrases appearing in section 3 is:
Not Applicable
This is the first version in the GHS SDS format. Listings of changes from previous versions in
other formats are not applicable.
Disclaimer: The information contained herein is considered accurate; however, F .E. Knight, Inc. makes
no warranty regarding the accuracy of the information. The user must determine the suitability of the
product for the intended use and accepts all risk and liability associated with that use.
End of Document
Page 8 of 8
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising