Utility Basket (9A439)
9A439001
Installation Instructions
INS-9A439001 (Rev. A)
Tools required:
Phillips head screwdriver
Electric Drill with Drive Extension
1/2” Drill Bit
Parts Included:
(1) CPU Mounting Bracket
(2) Sets of Mounting Bracket Assemblies
(4) 10-24 x 7/8” Long Phillips Drive Pan Head Machine Screws
(4) 10-24 x 1” Long Phillips Drive Pan Head Machine Screws
(4) 1/4-20 Heavy Duty Snap Togglers
(4) 1/4-20 x 2” Long Phillips Drive Pan Head Machine Screws
(2) Cable Ties
(1) Safety Strap
FOR COLUMN MOUNT:
1
Run screws into accessory
mounting bracket to within
1/16” of the bracket surface
2
Securely attach lower accessory
mounting bracket to the table
column at the desired height
3
Loosely attach the upper
accessory mounting bracket
4
Slip the HFH (Hanging
File Holder) accessory onto
the lower accessory mounting
bracket thru the keyhole slots
Attach HFH (Hanging File
Holder) accessory securely at
the top with the (2) screws
provided
Tighten the upper accessory
bracket to the table column by
tightening the screw shown
in #3.
Midmark Corporation | 60 Vista Drive | PO Box 286 | Versailles, Ohio 45380-0286 | USA | midmark.com
9A439001
Installation Instructions
INS-9A439001 (Rev. A)
Tools required:
Phillips head screwdriver
Electric Drill with Drive Extension
1/2” Drill Bit
Parts Included:
(1) CPU Mounting Bracket
(2) Sets of Mounting Bracket Assemblies
(4) 10-24 x 7/8” Long Phillips Drive Pan Head Machine Screws
(4) 10-24 x 1” Long Phillips Drive Pan Head Machine Screws
(4) 1/4-20 Heavy Duty Snap Togglers
(4) 1/4-20 x 2” Long Phillips Drive Pan Head Machine Screws
(2) Cable Ties
(1) Safety Strap
FOR WALL-MOUNT:
1
Caution
Properinstallationoftoggleboltsrequired
toprovidesecurewallmounting.Minimum
drywallthicknesstobe½”.
2
Once togglers are installed, attach Hanging
File Holder to wall by attaching and securing
with (4) 1/4-20 x 2” Long Phillips Drive Pan
Head Machine Screws.
Prior to installing CPU bracket assembly
to wall, follow instructions to install heavy
duty snap togglers into wall.
1.
(1/2” Hole)
Drill 1/2” size hole. Hold metal channel
flat alongside plastic straps and slide
channel through the hole. Minimum
clearance beind wall: only 1 7/8”
2.
3.
Midmark Corporation | 60 Vista Drive | PO Box 286 | Versailles, Ohio 45380-0286 | USA | midmark.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising