328034ENEU HVLPturboforce 7.0/9.0.9.5 quick operator's guide

328034ENEU HVLPturboforce 7.0/9.0.9.5 quick operator's guide
HVLP TURBOFORCE™ 7.0/9.0/9.5
Quick Operator’s Guide
WARNING
This procedure is for water-base paints and flushing fluids. For solvent-base paints and flushing
fluids (i.e. mineral spirits), you must read Fire and Explosion Hazard in the Operating Instructions.
* check the Graco operations manual delivered with the unit for more details.
SETUP
Connect air hose to sprayer. Hand tighten.
Fill cup 3/4 full.
Install cover. Latch
the gun cup cover to
secure it to siphon cup.
Connect air hose from sprayer to inlet fitting of gun.
CHOOSE THE RIGHT FLUID NOZZLE
For low flow rates or light
viscosity fluid, select smaller
nozzle sizes.
For high flow rates or high
viscosity fluid, select larger
nozzle sizes.
Material
Fluid Set #2
Fluid Set #3
Fluid Set #4
Fluid Set #5
Fluid Set #6
Part Number
Orifice Size
256946
0.032
256947
0.051
256948
0.071
256949
0.087
256950
0.098
Turbine Unit
Dye
Ink
Non-Wiping Stain
Automotive Finish
Lacquer
Stain
Enamel
Epoxy
Urethane
Varnish
Primer
Industrial Finishers
Latex
Multi-Spec
Butyrate
Nitrate Dope
Oil Wall Paint
7.0
9.0
9.5
NOTE: read gun manual for paint reduction recommendations.
OPERATION
(D)
HVLP EDGE™ Gun
www.graco.be
Set air cap to position
for spray pattern desired.
(E)
Verify trigger slide is in SPRAY position (E)
and not NEEDLE REMOVAL position (D).
SPRAYING
Nozzle
Plug turbine power cord
into a grounded outlet.
Turn turbine on.
Wait several minutes
prior to spraying to
allow warm-up time.
Air Cap
Turn air cap to obtain
desired direction.
Retaining Ring
Lock air cap with retaining ring.
Hold gun perpendicular, 15 to 20 cm
(6-8 inches) from surface. Move gun
first, then pull gun trigger to spray.
SHUTDOWN
Turn off turbine.
Unlatch cup.
CLEANING
Disassemble gun from cup and clean all parts with water.
OPTIONAL TRIGGERSTOP ADJUSTMENT*
Turn off turbine.
OPTIONAL ARTISAN AIR VALVE*
Remove air plug housing. Install Artisan air valve.
* With these options the HVLP-EDGE Gun works in the same way as the previous HVLP-Gun.
GRACO N.V. Industrieterrein Oude Bunders
Slakweidestraat 31 • B-3630 Maasmechelen
Tel: +32 (89) 770 700 • Fax: +32 (89) 770 777
E-mail: info@graco.be • http://www.graco.be
© 2009 Graco N.V. · Form No. 328034 E (rev.A) · 06/09 · Printed in Europe.
Graco is registered to I.S. EN ISO 9001.
All information, illustrations, and specifications in this document are based on the latest product information
available at the time of publication. The right is reserved to make changes at any time without notice.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising