HJ26025 - Autoslide Adapter for MOR/RYDE Install Instructions

9/15

HJ26025 Rev. 1

AUTOSLIDE ADAPTER FOR MOR/RYDE INSTALL INSTRUCTIONS

1) Remove four 9/16-12 bolts with 13/16 socket.

2) Push restraining rods toward center of box.

3) Slide spacer blocks into channel.

4) Install bolt through hole.

5) Install and tighten nut (self locker) x 4.

6) Slide Hijacker skid pad

(making sure wedge is to rear of box) into place.

7) Put plate in location using two 9/16-12” bolts opposite corners to hold plate.

8) Align opposite corners to restraining rods.

9) Align all 4 bolts before tightening.

12) Locking plates on hitch head are not needed when using this kit. They can be extended all the way out or removed.

10) Tighten all 4 bolts and torque to 85 ft-lbs.

11) Completed installation.

DEMCO • 4010 320th St. • Boyden, IA 51234 • www.towdemco.com

PH: (712) 725-2311 • Toll Free: 1-800-543-3626 • FAX: (800) 845-6420