Cut Square Rect

Cut Square Rect
Spa Cover Order Form
H2O Company Inc.
3000 South 300 West
Salt Lake City, Utah 84115
Ph(801) 486-9388 Fax(801)485-6836
Name:___________________________________________________ Date:____________________
Address: _____________________________ City:_________________ State: _____ Zip: ________
P.O.#: _______________ Phone: ________________________ Fax: _________________________
Spa Manufacturer: __________________________ Spa Model: ______________________________
Standard Colors: (Circle One)
Almond
Teal
Wildwood Brown
Desert Tan
Slate Grey
Premium Colors: (Circle One) Maui Sand
Moon Beam
Burgundy
Navy Blue
Redwood Rust
Hunter Green
Sky Blue
Skirt Size: (3-5" Standard)__________________
Tie Downs: (2 or 4 Standard) _______________
Specifications
Dimension
Size (inches)
A
Length
B
Width
C
Cut 1
C
Cut 2
C
Cut 3
C
Cut 4
WARNING!!!
Make sure measurements correspond to the direction of the fold ( dotted line ) pictured.
Notes:
1. Covers are made to the nearest inch, so round up when listing measurements (except on radius)
2. It is recommended to oversize covers by 1/2" on the overall length and width to allow the skirt to hang
straight over the side of the spa lip. DO NOT add 1/2" to radius or cut-corners
3. For instructions on measuring Cut-Corners, see next page below.
4. Not all cut-corners are the same. Make sure to measure each one seperately.
5. For best results measure the spa instead of old cover.
6. Kidney or irregullar cover shapes will require a full size template. Ask sales associate for details.
I authorize H2Oco. Inc. to order this Cover. I also Agree to purchase the cover specified above. I
understand that there is no return on special order covers and this order may not be cancelled for
any reason. Cover specifications were provided by the Spa Owner. Owner assumes responsibility
for cover specifications.
Spa Owner Signature: ___________________________________________ Date: ____________
Determining the Length of a Cut-Corner
1 Cut-Corner
If your spa has only 1 Cut-Corner, begin by determining the overall length (A) and the length of the
straight demension (B). Next, subtract the straight demension (B) from the overall length (A) and
multiply that by 1.41 This is the length of your cut. (Rounding is OK)
Eg. If A=84 and B=70
Then: 84-70=14.
14 x 1.41=20
Your measurment for C=20"
2 Cut Corners
If your spa has 2 Cut-Corners, begin by determining the overall length (A) and the length of the
straight demension (B.) Next, subtract the straight demension (B) from the overall length (A) then divide
this by 2 (since there are 2 corners) and multiply this number by 1.41 This is the length of each cut
(Rounding is OK)
Eg. If A=84 and B=62
Then: 84-60=24.
24/2=12.
12 x 1.41=17
Your measurment for C=17"
Warning!
If the Cut-Corners on your spa are different sizes, a full size template will need to be made.
Ask Sales Associate for details.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising