Evadale Touch Lamp User Guide

Evadale Touch Lamp User Guide
Touch Lamp
O p e r ation and Sa fet y I ns t r u ct i o n s
Please read before use. This lamp is for indoor use only.
Do not use if the power cord is damaged –
consult an electrician or contact Evadale for a replacement.
Unpacking your lamp
To operate
Remove all outer and inner packaging,
especially around the globe before use
OnTouch the metal
base ONCE to
turn on
1Remove the lamp from the packaging, and
discard all plastic wrapping
2Carefully remove the plastic wrapping that
is inside the lamp, protecting the globe.
OffTouch the metal
base again to
turn off
3Plug into mains power and switch on at the
power point.
Replacing the bulb
Specifications
1Unplug the lamp and let it cool down for at
least 10 minutes or until the bulb is cool to
touch.
Use only with 220-240 volt electricity
(standard Australian voltage).
2Unscrew the bulb and replace with a new
bulb of maximum 60W.
Use with a maximum watt globe of 60W
(a higher wattage bulb may damage the lamp).
Item numberTL-SQ
Lamp
E27 Energy Saving Lamp - Soft Start
Colour
Warm White
Cleaning the lamp
Voltage
220-240V ~ 50Hz
Unplug the lamp and let it cool down for at
least 10 minutes before cleaning.
Bulb
11W (60W standard bulb) E27 (’fancy’ threaded)
Lifetime
6000 hours / 3 years (approximately)
Warranty
1 year
Approval
Q02661 / AS/NZS 60598.2.4:2005
Place the lamp on a flat, clean surface and
gently wipe with a dry or slightly damp cloth.
www.evadale.com.au
Made in China
For more information
or to order, freecall
1300 883 194
©2012 Evadale Healthcare. All rights reserved.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising