6210 Installation Guide

How to install the VHF on desktop and overhead
INSTALLATION GUIDE
SAILOR 6210 VHF
What’s in the box?
USER & INSTALLATION MANUAL
SAILOR 6210 VHF
Sun Screen
Transceiver
Gasket
User & Installation
Manual
Wheel Knob
(2 pcs.)
Tilting ±20°
Screw M4x12
TORX 20 (3 pcs.)
U-Mounting
Bracket
Cradle
Screw ø3.9x19
TORX 20 (3 pcs.)
Flush Mount
Bracket (2 pcs.)
Handmicrophone
Screw M4x12
TORX 20 (5 pcs.)
Screw ø3.9x19
TORX 20 (5 pcs.)
Screw M4x45
TORX 20 (5 pcs.)
Square Nut
M4x7x2.2 (5 pcs.)
Fuse
6.3x3.2mm (10AT)
Power Cable
Drilling plan on desktop and overhead
4 x M4 or hole for
self-tapping ø3.9
53mm
9mm
71mm
What do I need to fit it?
23mm
150mm
196mm
Power Drill
Jigsaw
Screwdriver
TORX 20
Cable assembly for waterproof installation
How to install the VHF flush mount
Connect the 4 cable connections with rubber vulcanizing tape as shown .....
Square Nut M4x7x2.2 (4 pcs.)
Flush Mount Bracket (2 pcs.)
Gasket
1.
Screw M4x45 TORX 20 (4 pcs.)
Connect to LOUD HAILER
(RED isolation on inner connector)
A
B
Max wall thickness 26mm
99-130249
Drill for M4 or
Ø3.9 self-tapping
Connect to POWER +
(RED wire)
A
B
3.
2.
Connect to POWER (BLUE wire)
Connect to EXT. SPEAKER
(WHITE isolation on inner connector)
99-130248
Not
e!
Note!
-
Firmly tie back and secure any wires not used in order to
avoid possibility for mutual shorting or shorting to ground!
-
To ensure waterproof sealing:
If the surface isn’t plane and/or rigid remove the gasket and
seal with silicone sealant between the VHF and the surface.
Very important information!
4.
How to install the handmicrophone cradle
Do not remove the membrane.
If you remove the membrane the radio will not be waterproof.
Membrane
TT98-128464-THR-G
Thrane & Thrane A/S • info@thrane.com • www.thrane.com
Mounting template for handmicrophone cradle
INSTALLATION GUIDE
34.6mm
IMP
OR
T!
IMPOR
ORTTAN
ANT!
If this template was printed from an electronic
file or copied, scaling (1:1) may not be correct.
Consequently do not attempt to use a printed
or copied template without prior checking of
dimensions.
SAILOR 6210 VHF
46.8mm
2 x M4 or hole for
self-tapping ø3.9
28.5mm
Scale 1:1
Cutout template for flush mounting of the VHF
IMP
OR
T!
IMPOR
ORTTAN
ANT!
If this template was printed from an electronic
file or copied, scaling (1:1) may not be correct.
Consequently do not attempt to use a printed
or copied template without prior checking of
dimensions.
R2.5mm x 4
89mm
Flush mount template
177mm
Remove material from shaded area only!
Scale 1:1
System Configuration - Example
RX/TX
Aerial
SAILOR 6201
Handset
SAILOR 6202
Handmicrophone
Service
Cable
SAILOR 6204/05
SAILOR 6204/05
SAILOR 6204/05
Control
Control
Control
Speaker Microphone Speaker Microphone Speaker Microphone
VHF
6210
DISPLAY
DISPLAY
(HH størrelse)
(HH størrelse)
U
MEN
Push =
Enter
U
MEN
Push =
Enter
SQ
Hi/Lo
CALL
OR
16/9
CALL
VOL
16/9
Power
SAILOR 6208
Control Speaker Microphone
Connection Box
N163S
24V DC
U
MEN
SQ
Hi/Lo
CALL
VOL
16/9
SAILOR 6201
Handset Option
SAILOR 6209
Accessory
Connection Box
External
DSC Modem
N420
ACC. Port
12V Battery
DISPLAY
(HH størrelse)
Push =
Enter
SQ
Hi/Lo
VOL
12V DC
Loud Hailer (4 ohm)
Not
e!
Note!
The SAILOR 6204/05 Control Speaker Microphone
is not yet available.
External
Speaker (8 ohm)
110/220V AC
99-130265-A
TT98-128464-THR-G
Thrane & Thrane A/S • info@thrane.com • www.thrane.com
Download PDF