Connecting Delphi XM SKYFi to Your Vehicle With an

Connecting Delphi XM SKYFi to Your Vehicle With an
R a d i o t o t h e p o w e r o f X™
To vehicle
audio/stereo
To ground
(black)
+
(red)
(female)
Connect the red (+) lead to the vehicle
12V power terminal, which is powered
when the ignition is in the accessory
position.
88.1MHZ
88.5MHZ
AUDIO
IN
TO FM
ANTENNA
MADE IN MALAYSIA
87.9MHZ
Frequency switch
SKYFi Car Cradle
XM Antenna
To vehicle
AM/FM
antenna
Note: Connect FM modulator ground
terminal to vehicle ground before making any
other connections.
+
(male) (red)
6V DC
OUT
TO FM
RADIO
12V DC
IN
SKYFi Universal Adaptor
FM Modulator
DELPHI SA 10003
To vehicle
12V power
terminal
Connecting Delphi XM SKYFi
to Your Vehicle With an FM
Modulator
Audio In
The 12V power connecting cord is
permanently connected for SKYFi™ FM
modulation.
6V DC In
The SKYFi name, XM name, and related logos
are trademarks of XM Satellite Radio Inc.
Turning on the FM Modulator
Changing the Transmitting Frequency
With ignition in the accessory position, this FM
modulator is always on in a standby condition.
When you turn on your SKYFi Receiver, the FM
modulator will automatically switch the vehicle
stereo input from your FM antenna to an XM®
Satellite Radio signal.
The FM modulator allows you to change the XM
Satellite Radio broadcast signal to an FM
frequency and output the sound to your vehicle
radio via an FM station. You may experience
some interference if a local FM station is broadcasting at the same frequency. If this occurs,
change your FM modulator frequency using the
switch on the side of the unit. The switch has
three frequency settings: 87.9MHz, 88.1MHz,
and 88.5MHz. Note: Reset the vehicle stereo
frequency to the same value as the FM modulator frequency.
Installation Note: The FM antenna connector
used to connect the FM modulator to the
audio/stereo system may require an additional
adaptor. Some audio/stereo systems have AM
antennas that require an active bias from your
vehicle’s audio/stereo system. If AM reception is
not restored, try a different adaptor that will allow
the active bias to reach the AM antenna.
Professional installation is recommended.
Printed on Recycled Paper
©2003 Delphi Corporation. All rights reserved.
DPSS-03-E-039
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement