M1100-1-2 - SystemOne StartUp Sheet (Obsolete System)

M1100-1-2 - SystemOne StartUp Sheet (Obsolete System)
FRP SystemOne
Pumping System
Start-Up Sheet
Quick List Instructions
Daily Settings:
Solvent Pressure
________________
Gun Pressure ________________
Pump Pressure
________________
Nozzle P/N
________________
Catalyst %
________________
1.
Check & fill solvent system
2.
Check & fill resin &
catalyst supply
3.
Place suction wand in
resin supply
4.
Prime resin pump
5.
Prime catalyst pump and
set catalyst percentage
6.
Check system for fluid leaks
7.
Set air pressure to
gun/chopper
8.
Install turbulent mixer in
mix chamber
9.
Select spray tip, flow nozzle
or convergence tip
10. Check chopper motor,
rubber roller adjustment
11. Attach chopper cover & chute
12. Adjust fan pattern
13. Adjust chop pattern
14. See installation sheet and
manual for further instructions
Part No. M1100-1-2
This system is obsolete. This manual is for operational information
purposes only.
MVP recommends replacing with UltraMAX™ or Patriot™ System.
FRP SystemOne
Pumping System
Installation & Setup
Quick List Instructions
1.
Unpack unit & components
2.
Place unit & stand pipe in
base plate or portable cart (or
mount to wall with wall brackets)
Tighten bolts to secure
3.
Install catalyst jug
4.
Install resin surge chamber &
filter assembly
5.
Install manifold air hose to
power cylinder
6.
Attach hose fittings to resin
pump, catalyst pump, air &
flush tank
7.
Install boom to mast
(if applicable)
8.
Hang hose on boom
(if applicable)
9.
Attach pickup hose
10. Place flush tank in holder and
attach air hose from manifold
11. Double check all hose fittings
12. See start-up sheet and manual
for further instructions
Part No. M1100-1-2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement