BEA BESAM 300/400 ETIK2 door control system Instruction manual

Below you will find brief information for door control system BESAM 300/400 ETIK2. The document is an instruction manual for installing, configuring, and troubleshooting the BESAM 300/400 ETIK2 door control system. It includes detailed diagrams, wiring instructions, notes about installation requirements, and troubleshooting tips.

PDF Download
Document
BESAM 300/400 ETIK2 Instruction Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Supports safety side Q-disconnect
  • Includes instructions for both right-hand and left-hand motors
  • Has a detailed wiring diagram
  • Provides troubleshooting tips
  • Uses SUPERSCAN QUICK DISCONNECT
  • Uses LO-21P motor

Frequently asked questions

The system requires a LO-21P motor.

The N/O contact of the B-switch should close at approximately 65-70 degrees.

If after troubleshooting a problem a satisfactory solution cannot be achieved, call BEA for further assistance during Eastern Standard Time at 1-800-523-2462 from 8 AM - 5 PM.
Preparing document for printing…
0%