1072676 A IFS ESP-300 Quick Installation Guide

1072676 A IFS ESP-300 Quick Installation Guide
IFS ESP-300 Quick Installation
Guide
P/N 1072676 • REV A • ISS 09JAN14
Copyright
© 2013 United Technologies Corporation
Interlogix is part of UTC Climate Controls &
Security, a unit of United Technologies
Corporation. All rights reserved.
Trademarks and
patents
The IFS ESP-300 name and logo are trademarks
of United Technologies.
Other trade names used in this document may be
trademarks or registered trademarks of the
manufacturers or vendors of the respective
products.
Manufacturer
Interlogix
3211 Progress Drive, Lincolnton, NC 28092 USA
Authorized EU manufacturing representative:
UTC Climate Controls & Security B.V.,
Kelvinstraat 7, 6003 DH Weert, Netherlands
Version
Certification
FCC compliance
ACMA
compliance
This document applies to IFS ESP-300 version
1.0.
N4131
Class A: This equipment has been tested and
found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not
installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the user
will be required to correct the interference at his
own expense.
Notice! This is a Class A product. In a domestic
environment this product may cause radio
interference in which case the user may be
required to take adequate measures.
Canada
European Union
directives
This Class A digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe A est
conforme á la norme NMB-003du Canada.
2004/108/EC (EMC directive): Hereby, UTC Fire
& Security declares that this device is in
compliance with the essential requirements and
other relevant provisions of Directive 2004/108/EC
2002/96/EC (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
www.recyclethis.info.
Contact
information
For contact information, see www.interlogix.com
or www.utcfssecurityproducts.eu.
Content
1. Installation 1
IFS ESP-300 Quick Installation Guide
i
1. Installation
Thank you for purchasing IFS Ethernet Lightning Arrest Box ESP300, the Ethernet
Lightning Arrest Box package shall contain following contents:
Check the contents of your package for following parts:
z
Ethernet Lightning Arrest Box x1
z
Quick Installation Guide x1
z
Ground cable x1
If any of these pieces are missing or damaged, please contact your dealer
immediately, if possible, retain the carton including the original packing material,
and use them against to repack the product in case there is a need to return it to us
for repair.
Please refer to following procedure and picture to install the Ethernet Lightning
Arrest Box between two Ethernet devices.
Step 1: In the right side, please use the ground cable from the package to connect
the screw and ground. This ground needs to tie to Earth ground and be as
short as possible.
Step 2: Please connect first Ethernet device to the RJ-45 port that near the screw
through the UTP cable.
Step 3: Please connect second Ethernet device to another RJ-45 port from other
side of Ethernet Lightning Arrest Box.
Figure 1: ESP300 Application
IFS ESP-300 Quick Installation Guide
1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement