EMQ FPS 1101
10/100Mbps Direct Attached Print Server
FPS-1101
Quick Installation Guide
Table of Centents
Before you start, you should prepare the following items..................................... 3
Wired Network with Print Server........................................................................ 3
Hardware Installation........................................................................................ 3
Software Installation......................................................................................... 4
Before you start, you should prepare the following
items:
● One Windows-based PC with print server setup CD
● One printer and it’s installation CD
● One HUB and network cables
Wired Network with Print Server:
Printer
Print Server
HUB
Computer
Computer
Computer
Hardware Installation:
1.Turn off the printer’s power.
2.Connect the print server to your printer directly.
3.Turn the printer’s power on.
4.Plug the AC power adapter into the power connector on the print server.
5.Wait 10 seconds as part of the print server’s Power On Self Test (POST).
3
Software Installation:
1.To enable network communication with print server, your computer must have a
proper IP address, e.g. 192.168.0.100
2.Insert the setup CD into your CD-drive to initiate the autorun program.
3.Click on Setup Wizard hyperlink to install the print server and configure the
connected printer.
4.Click Next, the wizard will discover the print server automatically.
4
5.From the Select A Print Server screen, select the print server that you want to
configure and click Next.
5
6.On the Change Settings screen, select No or Yes:
Click No if you want the print server to keep using the default IP address and keep
the default settings, and then click Next.
● IP address: 192.168.0.10
● Subnet Mask: 255.255.255.0
Click Yes if you want change IP address to the print server, and then click Next.
Note
6
The IP address of print server must be within the same subnet as
your network adapter.
7.On the Select A Printer screen, select an already configured printer from the
list, click Next and then Finish to complete the installation.
or
Select Add New Printer if the print server is connected to a printer that hasn’t
been installed before and does not appear in the list.
7
8.Click Add New Printer to launch Windows Add Printer Wizard.
9.Click Next and select Local Printer, make sure the Automatically detect and
install my Plug and Play printer check box is NOT checked. Then click Next.
8
10.Make sure the Use the following port radio-button is clicked and select LPT1:
(Recommended Printer Port) from the pull-down list. Then click Next.
11.Select Manufacturer and Printer from the lists of printer’s driver. Then click
Next.
9
12.If you already have the printer’s driver installed, you will be asked whether to
keep it or to replace it. Click Next. Supply a name for the printer and choose
whether you want to make it your default printer. Then click Next.
13.Then, choose whether you want to share the printer with other network users,
print a test page (please select No.), etc. Select the appropriate radio-button
and click Next and Finish.
14.In the setup wizard, finish the installation by highlighting the installed printer in
the Select a Printer list and click Next -> Finish.
10
15.From Windows system, go to start -> Printers and Faxes and highlight your
newly installed printer.
16.Right-click, select Properties -> Ports and verify that the print server’s port
appears.
11
17.Go to General; click Print Test Page to verify the configuration.
18.Done.
Note
If you wish to install more print servers, start setup wizard from
your Windows Start menu: start -> All Programs -> Network
Print Server -> PSWzard and repeat the installation procedure.
All contents are subject to change without prior notice.
12
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement