B.E.A., INC. Stanley MP Control with LO-21P automatic door control Installation manual
Below you will find brief information for automatic door control Stanley MP Control with LO-21P. This document provides detailed instructions on how to install and connect the Stanley MP Control with LO-21P to a power source. The installation process involves connecting wires to different terminals, including the power supply, safety switch, and operating sensor. This manual also explains how to adjust the settings of the control panel, including the speed of the door, the sensitivity of the safety sensor, and the duration of the opening and closing cycles. It is important to follow the instructions carefully to ensure proper operation and safety.
Advertisement
Advertisement
Advertisement
Key Features
- SuperScan Quick Disconnect Cable
- Magic Force Auxiliary Switch
- Safety/Stall Sensor
- 12 VAC Auxiliary Input
- Door Control SW2 Switch Bank
- Hold Open Feature
- Auto Feature
- Safety & Stall Sensor
- Detailed wiring diagrams
- Troubleshooting tips
Frequently Answers and Questions
What is the purpose of the Magic Force Auxiliary Switch #4?
The Magic Force Auxiliary Switch #4 should open at approximately 65-70 degrees. For Magic Swing refer to Inhibit Switch BEA PT# 10 SSINHL or 10SSINHR.
What is the function of the Bodyguard Relay Output?
The Bodyguard Relay Output function must be changed to #2.
What is the purpose of the Door Control SW2 switch bank?
The Door Control SW2 switch bank set dipswitch #1 & 3 to the Off (timer) position.
What is the purpose of jumper 6 & 8?
Install Jumper 6 & 8.
What is the purpose of installing the blue and white wire into pins 6 and 1?
Install blue wire into pin 6. Install white wire into pin 1.