DSNLFAC
Item _____________________________________
Quantity _________________________________
NLFAC
CSI Section 11400
Approved ________________________________
Self-contained Milk or Beverage Dispenser with Air Curtain
Date _____________________________________
Models
•
•
•
NLFAC-8
NLFAC-12
NLFAC-16
8 crate milk or beverage dispenser
12 crate milk or beverage dispenser
16 crate milk or beverage dispenser
Standard Features
• Refrigerated temperature maintain
• Cabinet to be 18-gauge stainless steel
• Product will maintain 40°F (4°C) for
• Cabinet
bottom
to
be
14-gauge
galvanized steel
• Interior liner to be water-tight 22-gauge
stainless steel
• 1” diameter drain
• Units insulated with foamed in place
environmentally friendly, Kyoto Protocol
Compliant, Non ODP (Ozone Depletion
Potential), Non GWP (Global Warming
Potential) polyurethane
• (2) Hinged lids with locks, molded of
black ABS plastic
• 18-gauge dividers self locate milk crates
• Patented “air curtain” design
• (2) Evaporator coils
NLFAC-12
• Refrigeration system to be HFC-134A
• Expansion valve and thermostat control
36°F to 40°F (2°C to 4°C)
2 hours with lids open
• (4) 5.00” diameter polyurethane
swivel casters (two locking)
• 8’ cord and plug supplied
• One year parts and 90 days labor
warranty
Options &
Accessories
• Tray slide
• Laminate finish
• Fiberglass panels
• 220 volt, 50 Hertz electrical system
• Wrap-around bumpers (adds 1.75
[4.4cm] to overall length and
depth)
with automatic defrost
Specifications
Exterior Top, front and sides shall be 18-gauge stainless steel. An
opening shall be located in the top front of the unit to allow access
to the interior. Opening shall have a patented “air curtain” design,
with cold air forced over the opening to retain the cold air in the
interior of the unit. Opening shall have (2) hinged lids to cover the
top and front. Two-piece hinged lids shall be molded of black ABS
material, with an integral molded handle running the full length
of each front lid. Lids shall be seated in a PVC door track. Key
locks standard (one per door). Exterior bottom shall be 14-gauge
galvanized steel.
Properly chilled food product shall maintain 40˚F (4˚C) for up to 2
hours when lids are open.
Interior shall be 22 gauge stainless steel. Cabinet shall be
fully insulated with 2” (5.1cm) of high-density foamed-in-place
environmentally friendly, Kyoto Protocol Compliant, Non ODP
(Ozone Depletion Potential), Non GWP (Global Warming Potential)
polyurethane. Milk crates shall be self-locating in the interior with
the use of divider assemblies. Divider assemblies shall be 18-gauge
stainless steel. Unit shall have (2) 20-gauge stainless steel louvers,
which shall be centered left to right on the front and rear of the
equipment. The rear louver hinges upward for mechanical access.
A 0.75” (1.9cm) diameter valve shall be located at the bottom of the
equipment, centered left to right, 4.75” (12.1cm) from the rear wall.
Casters: Equipment shall be mounted on (4) 5” (12.7cm) diameter
plate casters. Two shall be locking.
Refrigeration system shall use HFC-134a refrigerant. Refrigerant
flow shall be controlled by an expansion valve. Cabinet shall
maintain 36˚F to 40˚F (2˚C to 4˚C) interior cabinet temperature at
100˚F (38˚C) ambient room temperature with lids closed for storage.
980 S. Isabella Rd.
Mt. Pleasant, Michigan 48858
Refrigeration system shall be controlled by a solid state thermostat
with a built in defrost timer. Control shall be accessible through the
rear louvered panel.
Electrical connections shall be 115 volt, 60 Hertz, single phase.
Unit shall have an 8’ (2.4cm) long electrical cord and NEMA 5-15 P
plug installed at the rear, 14” (30.5cm) from the left end, 6” (15.2cm)
above floor.
NLFAC-8 unit shall hold (8) 13” x 13” x 10.50” (33.0cm x 33.0cm x
26.7cm) milk crates. Compressor shall be 1/3 h.p., with condenser
coil, (2) evaporator blower coils and condensate evaporator.
NLFAC-12 unit shall hold (12) 13” x 13” x 10.50” (33.0cm x 33.0cm x
26.7cm) milk crates. Compressor shall be 1/2 h.p., with condenser
coil, (2) evaporator blower coils and condensate evaporator.
NLFAC-16 unit shall hold (16) 13” x 13” x 10.50” (33.0cm x 33.0cm x
26.7cm) milk crates. Compressor shall be 1/2 h.p., with condenser
coil, (2) evaporator blower coils and condensate evaporator.
Phone: 800-733-8948 or 989-773-7981
Fax: 800-669-0619
www.delfield.com
®
NLFAC: Self-contained Milk or Beverage Dispenser with Air Curtain
Project ___________________________________
32.00”
81cm
32.00”
81cm
54.00”
137cm
40.00”
102cm
Plan View
NLFAC-8
Plan View
NLFAC-12
Elevation View
NLFAC-8
Elevation View
NLFAC-12
Self-contained Milk or Beverage Dispenser with Air Curtain
NLFAC
32.00”
81cm
68.00”
173cm
Plan View
NLFAC-16
Elevation View
NLFAC-16
42.50”
108cm
5” Diameter caster
with brakes exposed
on ends
1.00”
2.5cm
Installation Note:
Refrigeration system is designed so that air will flow into the front
louver, through the compressor area, and out the rear louver. Any
restriction to this air flow path will void the warranties.
Right End View
All NLFAC Models
Specifications
Model
Crate
Capacity
Storage
Capacity
H.P.
V/Hz/Ph
Amps
NEMA Plug
Ship Weight
NLFAC-8
8
12.6ft 3 (0.36m 3)
1/3
115/60/1
7.0
5-15P
401lbs (182kg)
NFLAC-12
12
18.5ft (0.52m )
1/2
115/60/1
9.0
5-15P
491lbs (223kg)
NLFAC-16
16
24.3ft (0.69m )
1/2
115/60/1
11.0
5-15P
583lbs (264kg)
980 S. Isabella Rd.
Mt. Pleasant, Michigan 48858
3
3
3
3
Phone: 800-733-8948 or 989-773-7981
Fax: 800-669-0619
www.delfield.com
Printed in the U.S.A.
DSNLFAC
10/12
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement