Campomatic RC20BL Owner's Manual

RC20BL

Wet & Dry

Dual Purpose Vacuum Cleaner

INSTRUCTION MANUAL

:

WWW.CAMPOMATIC.COM

Made in China

Characteristic

Dry & Wet Dual Purpose

1400W Strong Suction

Cord Retractable

Safety Protection Device to ensure normal work of the motor

Base with jack to store accessories easily

Blowing function to satisfy deferent people’s requirement

Name of Parts

RC20BL

ENG

2

RC20BL

You can choose suitable accessories for different condition.

Floor Brush

Press down the side of bristle button with mark “ ”and then use the bristle extended for hard floor. Press down the side of bristle button with mark “━”and then use the bristle retracted for hard floor.

Absorbing Brush

For clean the water on the hard floor or the carpet.

Triangle Brush

For cleaning bookshelf, windows, desktop etc.

ENG

Crevice Tool

For cleaning corner edge and draws etc where is difficult to clean.

Blowing Door

3

RC20BL

For blowing the dust in the gap.

Warning

1. Read this instruction booklet carefully.

2. This appliance is for domestic use only. Use as described in this instruction booklet.

3. Before using the appliance, check if the mains power voltage corresponds to the voltage shown on the rating plate.

4. It is class Ⅱ electric appliance, so it need not be earthed.

5. Do not use it in the flammable and explosive place.（Fig1）

6. Do not block the flow of air. Blocking the air suction or exit may damage the motor. (Fig2)

ENG

Fig1 Fig2

7. Do not use the appliance to vacuum all the latter things: lighted stub ,hot ashes and other combustible things (Fig3)

Fig3 Fig4 those matter due to oil (Fig4) sharp matter (Fig5)

Fig5 Fig6

4

RC20BL those tiny powder like power of lime, land plaster etc. They may block the filter bag and the flow of air. It may damage the motor.

(Fig6) those things that can produce lather like washing powder, cleanser etc. There may be some bubble blowing from the air exit. Please dry it first and then restart it.

8. Do not turn over the vacuum cleaner. Otherwise the water may enter the motor to damage it.（Fig7）

Do not use the appliance as a lift pump.

We suggest you do not use it as a producer’s equipment.

Fig7 Fig8

9. Always remove the plug from the power socket when the appliance is not in use and before carrying out any cleaning or maintenance operations.

10. Keep the vacuum cleaner away from direct irradiation sunshine and the place with high temperature. Heat can deform and discolor the plastic parts of unit. (Fig8)

11. Check the hose periodically. Replace it in time if there is any way damaged. (Fig9)

Fig9 Fig10

12. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarity qualified person in order to avoid a hazard. (Fig10)

ENG

5

RC20BL

How to use

1. Ready for use

Connection

Insert the flexible tube into the air intake duct. To do this, slide intake duct cover insert the tube and press until it clicks into position. (Fig11)

To remove it, press down the button and pull out the hose. (Fig12)

Fig11 Fig12

To use the blowing function, just need plug the hose into blowing door.

Connect the flexible tube, extensive tube and accessories correctly.

ENG

6

RC20BL

2. Switch on the appliance

Before use please check the filter bag is installed. Do not work with no filter back.

1. While pressing down the cable winding button with one hand, draw out the cable. When you find the yellow sign, please draw it slowly. If you find the red sign please stop drawing. Insert the plug into the power socket. If you need retract the cable, just press down the cable winding button. (Fig13)

2. Press the ON/OFF button to switch the appliance on. (Fig14)

Fig13 Fig14

Change the air power control knob on handle can adjust the suction. The greater air door the smaller suction.

Safety Device

When there is full of water in the dust barrel(about 16L), the float will be risen and the appliance will stop working. In addition you can hear abnormal sound. The power supply hasn’t been cut off yet at that time. So cut off the power supply immediately. And spill the water in the barrel. Restart the machine.

When the vacuum is overturned, the float will risen. In that case cut off the power supply and upturn the vacuum.

If you run the vacuum or leave it alone while the float is risen, it may damage the motor and lead to fire.

ENG

7

RC20BL

Maintenance

1. Clean the dust barrel

When finishing cleaning or the suction decreased obviously, cut off the power supply and empty the barrel in time.

Refer to the following steps:

(1) Release the lock button and lift the top cover. (Fig15)

(2) Before remove the fi shake it about 20 times up and down. (Fig16)

Fig15 Fig16

(3) Remove the filter bag and clean the dust in the barrel. (Fig17)

(4) Replace the bag and the top cover. (Fig18)

Fig17 Fig18

If you do not empty the barrel in time, the dust in the barrel will emit smell. So please clean the barrel periodically. Before use again dry it.

2. Clean the filter

If the filter bag is blocked badly, clean it with water. If you need you can use some neutrality cleanser.

(1) Remove the filter bag.

(2) Clean it (Fig19)

(3) Dry it (Fig20)

After dry it replace it according to primary steps.

Do not use boiled water to clean it or dry it wit fire.

3. Clean the vacuum cleaner and the accessories

ENG

8

RC20BL

Fig19 Fig20

Clean the accessories and vacuum with soft cloth dipping water or neutrality cleanser. (Fig21)

(1)Do not clean the body of vacuum cleaner in petrol or oil-like liquid. Please wipe it with water or neutral detergent.

(2)When you wipe the appliance please dry the soft cloth by screwing.

Remove the sundries adhering to the floor brush with old toothbrush every month. (Fig22)

Fig21 Fig22

Troubleshooting

Motor work

Trouble doesn’t

Suction decrease

Check Part Resolve

Power Plug If it doesn’t plug in, plug in.

Hose

If hose is blocked, clean it. If straight tube doesn’t connect well, connect it well.

Dust Barrel If there is full of dust or water, empty it.

Hose comes away from the seat

Filter Bag If it is blocked, clean it.

Hose

Connection

Plug the hose into the seat.

9

RC20BL

Technique parameter

Model No.

Power

XXXX 1400W

Circuit diagram

Voltage

220-240V～

Frequency

50/60Hz

ENG

10

RC20BL

ً

ً

.ً

•

•

•

•

11

AR

RC20BL

12

AR

RC20BL

13

AR

Fig7 Fig8

Fig9 Fig10

RC20BL

8

9

10

11

12

13

AR

14

RC20BL

II

5

6

7

1

2

3

4

Fig1 Fig2

Fig3 Fig4

Fig5 Fig6

15

AR

RC20BL

–

.

16

AR

RC20BL

1400W

RC20BL

220-240~ 50-60Hz

:

17

AR

RC20BL

ﺥﺎﺳﻭﻻﺍﻭ ءﺎﻤﻠﻟ ﺔﻴﺋﺎﺑﺮﻬﻛ ﺔﺴﻨﻜﻣ

Campomatic S.R.L. Via Configliachi 5/B . 35031, Abano Terme (Padova), ITALIA

WWW.CAMPOMATIC.COM