Quick Start Guide - LW2231 Wireless Security Camera

Quick Start Guide - LW2231 Wireless Security Camera
W IR E LE S S DIGITAL SECU R ITY C A MER A
LW2231
QUICK START GUIDE
Getting Started
A. Installing the Camera
1
Mount the camera to the wall or ceiling using the
included screws. Use the included anchors as needed.
2
Cable Notch
NOTE:
For outdoor use, installation in a
sheltered location is recommended.
This system comes with the
following components:
1x
1x
1x
1x
2x
1x
1x
2x
wireless camera
wireless receiver
antenna for camera (pre-attached)
antenna for receiver (pre-attached)
power adapters (for camera and receiver)
BNC-to-RCA adapter
camera mounting kit
double-sided tape for receiver
Determine where you will route the
cable that connects the camera to the
power adapter.
Verify the camera’s performance by
observing the image on a monitor when
the camera is positioned where it will be
permanently installed.
Avoid installing the camera in a location where
the wireless signal must pass through cement,
concrete, or metal structures. This will reduce
the transmission range.
1
3
Connect the camera power adapter
to the camera. Connect power
adapter to a 120V AC power outlet.
2
3
Power cables are only weatherproof when fully inserted
at the connection point. Power cables should not be
submerged in water.
4
Remove protective film from the
camera lens.
B. Connecting to a DVR
1
Connect the BNC cable to your
DVR’s video input.
3
Connect the receiver
power adapter to
the receiver. Connect
the power adapter to
a 120V power outlet.
BNC video
2
Connect the RCA cable to the
corresponding DVR audio input
(e.g. Video Input 1 / Audio Input 1)
Installation Tips
Before you permanently install your camera:
Plan where and how they will be
positioned.
If you run the cables
along the wall / ceiling,
you must run the cable
through the cable notch
on the base. This will
keep the camera base
flush to the wall /
ceiling when mounted.
Loosen the two
thumbscrews (1,2)
and the adjustment
ring (3). Adjust the
angle of the camera
until the desired
view is set. Tighten
the thumbscrews
and the adjustment
ring to secure the
camera position.
ATTENTION: Make sure to first
connect and power on the camera
before powering on the receiver.
4
RCA audio
CONNECTING to TV:
Connect the included BNC-to-RCA adapter to
the BNC connector on the receiver.
Connect the other end of the adapter to the
video input on your TV. Connect the RCA
cable from the receiver to the audio input on
your TV. Select the input for your camera on
the TV.
OPTIONAL:
Use the double-sided
tape to securely attach
RCA audio
the receiver to a flat
surface.
* BNC-to-RCA adapter attached.
Need to extend the wireless range?
See instruction manual for further details.
REGISTER NOW TO RECEIVE
3-MONTHS EXTENDED WARRANTY
Installing Multiple Wireless
Cameras
When installing multiple digital wireless
security cameras in the same environment,
maintain at least 4” / 10cm between the
receivers to optimize camera performance.
NOTE: It is not recommended to install more
than 4 digital wireless security cameras in the
BNC video*
same environment to maintain optimal video
frame rate performance.
It’s all on the Web
Scan the QR code or go to the address
below for the complete user’s guide.
lorex.ca/LW2230
www.lorextechnology.com/warranty
LW2231_QSG_EN_R3
www.lorextechnology.com
Page 1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement