EMQ-ANTFP18A v3.0
ANT-FP18A
5GHz 18dBi Flat Panel Antenna
※ SPECIFICATION
● Frequency:5100~5900 MHz
● Max gain:18dBi
● Connector:N female
● Max input power:10W Max
● Wave impedance:50 OHMS ±5Ω
● Dimensions:270x205x15mm
● Weight:990g
● For image/Data/Voice communication and Wireless LAN system
-1-
-2-
OUTDOOR INSTALLATION WARNING
!
IMPORTANT SAFETY PRECAUTIONS:
LIVES MAY BE AT RISK! Carefully observe these instructions and any special instructions that are included with
the equipment you are installing.
CONTACTING POWER LINES CAN BE LETHAL.
Make sure no power lines are anywhere where possible contact can be
made. Antennas, masts, towers, guy wires or cables may lean or fall and
contact these limes. People may be injured or killed if they are touching or
holding any part of equipment when it contacts electric lines. Make sure
there is NO possibility that equipment or personnel can come in contact
directly or indirectly with power lines.
Assume all overhead lines are power lines.
The horizontal distance from a tower, mast or antenna to the nearest power
line should be at least twice the total length of the mast/antenna combination.
This will ensure that the mast will not contact power if it falls either during
installation or later.
TO AVOID FALLING, USE SAFE PROCEDURES WHEN WORKING AT
HEIGHTS ABOVE GROUND.
Select equipment locations that will allow safe, simple equipment installation.
Š
Don’t work alone. A friend or co-worker can save your life if an accident happens.
Š
Use approved non-conducting lasers and other safety equipment. Make sure all equipment is in good repair.
Š
If a tower or mast begins falling, don’t attempt to catch it. Stand back
Š
If anything such as a wire or mast does come in contact with a power line, DON’T TOUCH IT OR ATTEMPT TO MOVE IT.
Instead, save your life by calling the power company.
Š
Don’t attempt to erect antennas or towers on windy days.
and let it fall.
MAKE SURE ALL TOWERS AND MASTS ARE SECURELY GROUNDED, AND ELECTRICAL CABLES CONNECTED TO
ANTENNAS HAVE LIGHTNING ARRESTORS. This will help prevent fire damage or human injury in case of lightning, static
build-up, or short circuit within equipment connected to the antenna.
Š
The base of the antenna mast or tower must be connected directly to the building protective ground or to one or more
approved grounding rods, using 1 OAWG ground wire and corrosion-resistant connectors.
Š
Refer to the National Electrical Code for grounding details.
IF A PERSON COMES IN CONTACT WITH ELECTRICAL POWER, AND CANNOT MOVE:
Š
DON’T TOUCH THAT PERSON, OR YOU MAY BE ELECTROCUTED.
Š
Use a non-conductive dry board, stick or rope to push or drag them so they no longer are in contact with electrical power.
Š
Once they are no longer contacting electrical power, administer CPR if you are certified, and make sure that emergency
medical aid has been requested.
Part No: 2011-E30130-001
-3-
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement