Husky Liners Installation Instructions 5633

Husky Liners Installation Instructions 5633
PART NO.
5633
UNIVERSAL MUD GUARD (FULL SIZE VEHICLES)
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Possible Tools Required:
• 1/8” & 1/4” drill bit / Drill
• Center punch / Hammer
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents
• Driver & passenger side mud guard
• 1” #10 screws (qty. 8)
• U-Clips (qty. 8)
• Plastic fasteners (qty. 2)
• Instruction sheet
NOTE: It may be necessary to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location areas on the fenders before installation. Determine if existing
factory fasteners and/or holes in the fenders can be used to mount the mud guards to the fenders. You may
still need to drill some holes to completely install your mud guards, but existing factory fasteners and holes
should be used wherever possible.
2. If existing factory fastener(s) can be used to attach the mud guards: Remove fastener(s), align mud guard,
mark factory hole location(s) on mud guard, drill 1/4” hole thru mud guard and attach mud guard to fenders with
factory fasteners.
3. If an existing fender hole(s) can be used to attach the mud guards: Align mud guard, mark factory hole
location(s) on mud guard, and drill 1/4” hole thru mud guard. Slide U-Clip over or place behind fender hole and
attach mud guard with #10 screw thru mud guard and fender and into U-Clip. Make sure mud guard is level
with ground before tightening fasteners. NOTE: A plastic fastener can be substituted for the #10 screw and UClip depending on hole size.
4. If some or all holes need to be drilled into fender: (Figure 1) Align mud guard, mark and drill 1/8” hole
(approx 1/4” from top of mud guard where possible) and attach mud guard to fender with a #10 screw. Make
sure mud guard is level to ground before tightening. With mud guard in place, mark and drill remaining holes
and fasten with #10 screws. Space mounting holes evenly to insure maximum support of mud guard.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer
5633 Universal Instructions.doc
Rev: 0
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement