Spec HXC4D

Spec HXC4D
Product
Specifications
HXC4D-1TW
APPLICATION
• Fits in standard wallboxes and replaces regular switches.
Note: The HXC4D-1TW does not control the load.
• Four sets of ON/OFF buttons provide 3, 4, 5-way etc.,
control of four sequentially addressed receivers without the
need for traditional 3-way wiring, and without the need for a
dedicated traveler wire.
• One set of BRIGHT/DIM buttons transmits BRIGHT/DIM
commands to the most recently selected address.
Leviton’s HXC4D-1TW utilizes proven Power Line Carrier (PLC)
technology to control any manufacturer’s PLC power-handling
device that complies with the X-10 communications protocol
guidelines.
These devices include, but are not necessarily limited to:
- In-wall dimmers
- In-wall switches
- Plug-in dimmers
- Plug-in relay (appliance) modules
- Fixture dimming modules
- Fixture relay modules
- Low-Voltage interface modules for use with sprinkler systems,
drapery controls, home theater applications and more.
FEATURES AND BENEFITS
• Controls Leviton’s DHC devices as well as any other
manufacturer’s X-10 protocol compliant devices.
• Utilizes existing 60Hz 120V AC house wiring for
“No New Wires” installation, when neutral wire is present
in existing boxes.
• Leviton's patented Intellisense™ Technology greatly improves
reliability and reduces false responses compared to other
manufacturers' products by virtually eliminating signal
problems due to noise.
Cat. No. HXC4D-1TW
• Green LEDs illuminate to indicate ON command sent
or STATUS ON report received.
• Color change kits allow fast color changeovers. Devices
ship in White only. See chart for Color Change Kits
(must be purchased separately)
• May be used to control lights and loads remotely.
• Compatible with Decora screwless and Decora standard
designer wallplates.
SPECIFICATION SUBMITTAL
JOB NAME:
CATALOG NUMBERS:
JOB NUMBER:
Leviton Mfg. Co., Inc.
59-25 Little Neck Pkwy • Little Neck, NY 11362-2591 • Tech Line: 1-800-824-3005 • Fax: 1-800-832-9538
Visit our Website at: www.leviton-lin.com
DHC Four-Address Wall Mounted Dimming Controller HXC4D-1TW
Decora® Home Controls
Four-Address Wall Mounted
Dimming Controller
Product
Specifications
HXC4D-1TW
.............................
Meets all applicable standards:
Standard and Extended X-10 Code Format (XTC798)
UL Listed (File #E-66800)
CSA Certified (File #LR-54628)
UL 244A tested.
SPECIFICATIONS
Dimensions:
Rating:
Power Consumption:
Output Frequency:
4.40” H x 1.76” W x 1.40” D
120VAC, 60Hz
3W
120KHz
INSTALLATION CONSIDERATION
• Cat. No. HCA02-10E coupler/repeater must be installed in
every DHC installation to insure maximum signal strength.
• Maximum of 4 “transmit-capable” devices (controllers,
programmers and 2-way receivers) should be installed
on a single branch circuit.
COMMUNICATION
Transmits:
• Address ON – when any ON button is pressed, sends
command to all units with address (House code & Unit
code) corresponding to the button pressed on the
controller/transmitter.
• Address OFF – when any OFF button is pressed, sends
command to all units with address (House code & Unit
code) corresponding to the button pressed on the
controller/transmitter.
• Bright – when s button is pressed, brightens the last device
addressed on base House Code
• Dim – when t button is pressed, dims the last device
addressed on base House Code
Unit requires that a Base address be set using a matrix of 8
buttons located behind the easily removed color change kit.
This base address, both House Code and Unit Code,
determines the range of address that the transmitter can
control. In this case (HXC4D) the base address will correspond
to the first, top-most set of ON/OFF buttons and the next
three (sequential) addresses, i.e. A1 (base), A2, and A3.
WARRANTY INFORMATION
Two year limited product warranty.
ORDERING INFORMATION
Cat. No.
Description
HXC4D-1TW
DHC Four-Address Wall Mounted
Dimming Controller
DRK4D-00I
DRK4D-00W
DRK4D-00A
LABEL KIT
DCK4D-0CI
DCK4D-0CW
DCK4D-0CA
Ivory Color Change kit
White Color Change kit
Almond Color Change kit
Ivory Color Change kit
White Color Change kit
Almond Color Change kit
DIMENSIONAL DIAGRAM HXC4D-1TW
1.40
(35.5 mm)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
2.69
(68.2 mm)
STANDARDS COMPLIANCE
PROGRAMMING
3.28 (83.3 mm)
The Four-Address Wall Mounted dimming controller controls
all properly addressed PLC devices that are X-10 compliant
and of the appropriate type via 120 KHz signals transmitted
over 120VAC, 60Hz power lines. It features Leviton’s
Intellisense™ Technology (gated automatic gain control). It
utilizes green LEDs that illuminate to indicate ON command
sent or STATUS ON report received. It is compatible with
Decora screwless and standard designer wallplates. It has
available color change kits in White, Ivory and Almond.
Receives:
• STATUS ON and STATUS OFF reports from any 2-Way
capable receivers whose addresses correspond to the
buttons on the controller when status of the receiver is
changed manually.
4.40 (112.0 mm)
TYPICAL SPECIFICATION
Note: Features and specifications are subject to change.
1.76
(45.0 mm)
1.60
(40.6 mm)
SPECIFICATION SUBMITTAL
JOB NAME:
CATALOG NUMBERS:
JOB NUMBER:
HXC4D-10W
Leviton Mfg. Co., Inc.
59-25 Little Neck Pkwy • Little Neck, NY 11362-2591 • Tech Line: 1-800-824-3005 • Fax: 1-800-832-9538
our Website at: www.leviton-lin.com
2 Visit
©2005 Leviton Manufacturing Co., Inc.
B-1100/D5 js
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement