Advertisement
Advertisement
KZPb
----------------------------------------------------------
INSTALLATION – WIRING
Figure 1. Maximum operating temperature.
Figure 4. Installation with CLA size 500 demand one meter
duct between CLA and KZP.
Figure 5. Optional location for circular position.
Figure 2.
Figure 6. Rectangular KZP are only allowed for damper blade
axle in horizontal position.
Figure 3. Installation with sound attenuation CLA without in-
ner baffle.
Registered design. The company reserves the right to make design changes without prior notice.
www.swegon.com - 13 September, 2006
1
KZPb
-----------------------------------------------------------------
WIRING
Figure 8.
Figure 7. Installation area requirements.
WIRING NOTES
Power supply 24 V AC (±10%). max 6 A fuse, wire area 1.5 mm
2
.
Wire for KSP min. 0,75 mm
2
and max. 0.75 m length to KZP.
Wire between 0 and M (dot dashed) is not necessary if the products are connected to the same transformer.
Figure 9. Wiring diagram.
Key to figures 8 and 9
1. KZP 4. Flow sensor
2. Pressure sensor KSP 5. Conn. for Hand terminal KOP
3. Controller KCP 6. Actuator
2 www.swegon.com - 13 September, 2006

Public link updated
The public link to your chat has been updated.
Advertisement