American Legend Power Play 7ft Air Hockey Table

American Legend Power Play 7ft Air Hockey Table
We strive to ensure that our products are of the highest quality
and free of manufacturing defects or missing parts. However, if
you have any problems with your new product,
DO NOT RETURN IT TO THE STORE,
please contact us toll free @:
1-888-996-2729
FAX: 1-866-873-3531
[email protected]
Or write to:
Escalade Sports
Customer Service Department
P.O. Box 889
Evansville,IN 47706
Please have your date code when inquiring about parts.
When contacting Escalade Sports please provide your model number, date code (if
applicable), and part number if requesting a replacement part. These numbers are
located on the product, packaging, and in this owners manual.
HT220
Your Model Number
2 - HT220 Date Code:
Purchase Date:
- MW
PLEASE RETAIN THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE
All Rights Reserved
© 2014 Escalade Sports
1
For Customer Service Call
1-888-996-2729
IMPORTANT! READ EACH STEP
IN THIS MANUAL BEFORE YOU
BEGIN THE ASSEMBLY.
TWO ADULTS ARE REQUIRED TO ASSEMBLE
THIS HT220 POWER PLAY 7FT AIR HOCKEY TABLE
Tools Required:
T1 - Allen Wrench (Included)
Phillips Screwdriver
Furniture Polish and Cloth
Assembly Tips
Make sure you understand the following tips before you begin to assemble your hockey table.
1. Start all bolts by hand before tightening.
2. Some drawings or images in this manual may not look exactly like your product. Please
read and understand the text before starting each assembly step.
READ AND FOLLOW ALL ASSEMBLY, OPERATION, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO
ADULTS ARE NEEDED TO PUT THIS HOCKEY TABLE
TOGETHER.
All Rights Reserved.
© 2014 Escalade Sports
2
For Customer Service Call 1-888-996-2729
H1 = 16 pcs
8mm x 32mm
Allen Head Bolt
H2 = 16 pcs
8.5mm x 19mm
Flat Washer
H3 = 18 pcs
3.5mm x 12mm
Phillips Round
Head Screw
H4 = 6 pcs
3.5mm x 18mm
Phillips Round
Head Screw
H5 = 8 pcs
6mm x 25mm
Allen Head Bolt
H6 = 8 pcs
6.5mm x 16mm
Flat Washer
H7 = 4 pcs
3.5mm x 12mm
Phillips Round
Head Screw
A1 = 2 pcs
Striker with Felt Pad
A2 = 4 pcs
Puck
T1 = 1 pc
Allen Wrench
P1 = 1 pc
Air Hockey
Table Cabinet
P2 = 2 pcs
Right Leg
P3 = 2 pcs
Left Leg
P4 = 2 pcs
Side Leg Panel
P5 = 2 pcs
End Leg Panel
P6 = 4 pcs
Leg Leveler
P7 = 2 pcs
Goalflex80 Goal
P8 = 1 pc
Goalflex80 Scoring
Console
P9 = 1 pc
Scoring Console
Holder
TM
TM
!
All Rights Reserved.
© 2014 Escalade Sports
3
WARNING:
CHOKING HAZARD
Small parts.
Not for children under
3 yrs.
For Customer Service Call 1-888-996-2729
PARTS REQUIRED:
1 pc - P1 Air Hockey Table Cabinet
16 pcs - H1 Allen Head Bolt
2 pcs - P2 Right Leg
16 pcs - H2 Flat Washer
2 pcs - P3 Left Leg
1 pc - A3 Allen Wrench
STEP 1:
Leave Hockey Table Cabinet P1 face down in carton to assemble.
Attach P2 Right Legs and P3 Left legs using H1 Allen Head Bolts with H2 Flat Washers as shown
in FIGURE 1.
Use T1 Allen Wrench to tighten bolts.
P3
H2
H1
H1
H2
P2
P2
P3
P1
FIGURE 1
All Rights Reserved
© 2014 Escalade Sports
4
For Customer Service Call
1-888-996-2729
PARTS REQUIRED:
12 pcs - H3 Phillips Round Head Screw
2 pcs - P4 Side Leg Panel
12 pcs - H5 Allen Head Bolt
2 pcs - P5 End Leg Panel
12 pcs - H6 Flat Washer
4 pcs - P6 Leg Leveler
1 pc - T1 Allen Wrench
STEP 2:
With the help of another adult, align the holes in the P5 End Leg Panels with the pre-drilled pilot
holes in the Legs and attach with H3 Phillips Round Head Screws as shown in FIGURE 2.
Important Note: Tighten, but do not strip out H3 screws.
Attach P4 Side Leg Panel as shown using H2 Allen Head Bolts and H3 Flat Washers.
Use the T1 Allen Wrench to tighten the bolts.
Thread the P6 Leg Levelers into the bottom of each leg.
P6
GOALFLEX
graphic face
outside.
P5
H3
GOALFLEX
graphic face
outside.
FIGURE 2
H6
H5
H6
All Rights Reserved
© 2014 Escalade Sports
5
For Customer Service Call
1-888-996-2729
PARTS REQUIRED:
2 pcs - P7 Goalflex80 Goal
6 pcs - H3 Phillips Round Head Screw
4 pcs - H4 Phillips Round Head Screw
THIS STEP REQUIRES TWO OR MORE ADULTS.
VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON
ITS LEGS. BE CAREFUL, THE TABLE IS HEAVY.
STEP 3:
With the help of another adult, carefully lift and rotate table into upright position.
First, feed the sensor plug from each P7 Goalflex80 Goal through each end apron as shown
in FIGURE 3A.
Next, use pilot holes provided to attach each P7 Goalflex80 Goal using H4 Phillips Round Head
Screws and H3 Phillips Round Head Screws as shown in FIGURE 3B.
Important Note: Tighten, but do not strip out H3 and H4 Screws.
Next, feed the plugs through underneath support beams and through
long side apron as shown in FIGURE 3C.
NOTE:
Use H4 Screws
this location.
Feed the sensor
plug from P7
through the
end apron.
H4
NOTE:
Use H3 Screws
this location.
H3
P7
FIGURE 3B
P7
FIGURE 3C
FIGURE 3A
All Rights Reserved
© 2014 Escalade Sports
6
For Customer Service Call
1-888-996-2729
PARTS REQUIRED:
1 pc - P8 Goalflex80 Scoring Console
1 pc - P9 Scoring Console Holder
2 pcs - H4 Phillips Round Head Screw
H4
FIGURE 4
P8
STEP 4:
First, feed the sensor plugs from P8 Goalflex80
Scoring Console through P9 Scoring Console Holder
as shown in FIGURE 4.
Attach P8 Goalflex80 Scoring Console to P9 Scoring
Console Holder using H4 Phillips Round Head
Screws as shown in FIGURE 4.
Important Note: Tighten, but do not strip out
H4 Screws.
Feed plugs
through these
holes.
P9
STEP 5:
Carefully connect P8 Console male connectors to P7 Goal female connectors as shown in
FIGURE 5.
RIGHT
END
Console
Connector
Goal
Connector
Console
Connector
LEFT
END
FIGURE 5
All Rights Reserved
© 2014 Escalade Sports
7
For Customer Service Call
1-888-996-2729
PARTS REQUIRED:
4 pcs - H7 Phillips Round Head Screw
STEP 6:
First, feed the connector wires back through hole on P1 Air Hockey Table Cabinet - Side Apron and
attach P9 Scoring Console Holder using H7 Phillips Round Head Screws as shown in FIGURE 6.
Important Note: Tighten, but do not strip out H7 Screws.
Install 3 “C” size batteries (not included) into P8 Goalflex80 Scoring Console.
Clean up hanging wires using four pieces factory installed Velcro Straps on under side of table.
NOTE: Small Phillips
Screwdriver required to
remove these 2 Screws
to remove cover for
battery installation.
Reinstall cover and
screws after batteries
are installed.
FIGURE 6
P8
P9
H7
For clarity,
Scoring wires
not shown.
INCORRECT P9
CONSOLE HOLDER
INSTALLATION
All Rights Reserved
© 2014 Escalade Sports
8
CORRECT P9
CONSOLE HOLDER
INSTALLATION
For Customer Service Call
1-888-996-2729
Congratulations! You have now assembled your Hockey Table. Please note the Care and Use instructions below
to ensure many years of trouble free use of your Hockey Table.
CARE AND USE OF YOUR HOCKEY TABLE
1 . Use only a suitable 120v AC household outlet, and insure the cord is not a trip hazard.
2 . For long life and best play from your air hockey table, apply spray furniture polish
to clean cloth and wipe down the playfield with air motor running to make the pucks
slide faster before first play and frequently thereafter.
3. This product is intended for INDOOR use only.
4. DO NOT operate the motor if the cord is damaged in any way.
5. DO NOT sit, climb or lean on the table.
6. DO NOT drag the table when moving it. This will damage the legs.
7. DO NOT set drinks on the table.
8. It is suggested that this table be placed close to wall thus allowing the air motor
cord to NOT be a trip hazard. Always turn air motor off when table is not in use.
PRODUCT PARTS LIST # HT220
Part#
HT220MWH1
HT220MWH2
HT220MWH3
HT220MWH4
HT220MWH5
HT220MWH6
HT220MWH7
HT220MWA1
HT220MWA2
HT220MWT1
Description
8 mm x 32 mm Allen Head Bolt
8.5 mm x 19 mm Flat Washer
3.5 mm x 12 mm
Phillips Round Head Screw
3.5 mm x 18 mm
Phillips Round Head Screw
6 mm x 25 mm Allen Head Bolt
6.5 mm x 16 mm Flat Washer
3.5 mm x 12 mm
Phillips Round Head Screw
Striker with Felt Pad
Puck
Allen Wrench
Qty
16
16
18
6
8
8
4
2
4
1
Part#
HT220MWP1
HT220MWP2
HT220MWP3
HT220MWP4
HT220MWP5
HT220MWP6
HT220MWP7
HT220MWP8
HT220MWP9
HT220MWC1
HT220MWK1
HT220MWM1
Qty
Description
Air Hockey Table Cabinet (no motor)
Right Leg
Left Leg
Side Leg Panel
End Leg Panel
Leg Leveler
Goalflex80 Goal
Goalflex80 Scoring Console
Scoring Console Holder
Blower Motor
Hardware Kit
Owner’s Manual
1
2
2
2
2
2
2
1
1
1
1
1
GOALFLEX ELECTRONIC SCORER OPERATION:
POWER ON/OFF = Press ON/OFF button to start the Goalflex scoring unit. Long press ON/OFF button
to turn off the Goalflex scoring unit.
GAME TYPE = Press GAME TYPE button to select POWER PLAY, SOLO or DOUBLE game type.
GOAL SIZE = Press GOAL SIZE button to adjust your goal size.
HANDICAP = Press HANDICAP button to select versus mode handicap options.
TIME = Press TIME button to select time options 20 , 15 , 10 or 5 minutes.
AFTER GOAL DELAY = Press AFTER GOAL DELAY button to turn off NON-STOP scores mode.
MUTE = Press MUTE button to turn the sound ON or OFF.
START/PAUSE = Press START/PAUSE button to START or PAUSE the game.
NOTE: If NO GAME TYPE has been select or the START/PAUSE button is not pressed for 3 minutes,
the scoring unit will automatically turn off. However we suggest turning the power off when the game
will not be used for an extended period of time.
All Rights Reserved
© 2014 Escalade Sports
9
For Customer Service Call
1-888-996-2729
90 DAY LIMITED WARRANTY
This customer warranty extends to the original owner, on the purchase of any ESCALADE
SPORTS Product (hereinafter referred as the "Product").
WARRANTY DURATION: This Product is warranted to the original owner, for a period of 90
days from the original purchase.
WARRANTY COVERAGE:ESCALADE SPORTS warrants to the original owner, this product
to be free from defects in material and workmanship when used for the intended purpose
under normal use and conditions. THIS WARRANTY IS VOID IF THE PRODUCT HAS BEEN
DAMAGED BY ACCIDENT, UNREASONABLE USE, NEGLIGENCE, IMPROPER SERVICE,
FAILURE TO FOLLOW INSTRUCTIONS PROVIDED WITH THE PRODUCT OR OTHER
CAUSES NOT ARISING OUT OF DEFECTS IN MATERIAL AND WORKMANSHIP.
WARRANTY REPLACEMENT: During the above 90 day warranty period,
ESCALADESPORTS shall provide replacement components or replace with a comparable
product at our choosing. If product is defective under normal use and proper care, please
contact our Customer Service Dept.
1-888-996-2729 / Customer Service Dept.
Or Write us at:
Escalade® Sports, Inc. - P.O. Box 889, Evansville, IN 47706
Attn: Customer Service Dept.
Or E-mail us at:
[email protected]
Other than shipping requirements, no charge will be made for such replacement of in-warranty
products.
WARRANTY DISCLAIMERS: ANY IMPLIED WARRANTIES ARISING OUT
OF THIS SALE, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION TO THE ABOVE 90 DAY PERIOD. ESCALADE SPORTS
SHALL NOT BE LIABLE FOR LOSS OF USE OF THE PRODUCT OR OTHER
CONSEQUENTIAL OR INCIDENTAL COSTS, EXPENSES OR DAMAGES
INCURRED BY THE CONSUMER OF ANY OTHER USE.
Some states do not allow the exclusion or limitation of implied warranties or consequential or
incidental damages, so the above limitations or exclusions may not apply to you.
LEGAL REMEDIES: This warranty gives you specific legal rights and you may also have
other rights which may vary from state to state.
All Rights Reserved
© 2014 Escalade Sports
10
For Customer Service Call
1-888-996-2729
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement