VTech | MI6866 | Quick Start Guide

STEP 1 Check package contents (mi6866)
Quick Start Guide
Make sure your phone’s packaging includes the following:
mi6896/6895/6870/6866
STEP 3 Battery installation
1. Align the two holes in the plug with the socket pins,
then snap the plug into place. Place the battery in the
compartment with the wires in the upper right corner.
2. Replace cover by sliding it upwards until it clicks into
place.
• Dial the phone number.
-OR• Dial the phone number.
• Press
.
Receiving a call
Press
OFF.
, SPEAKERPHONE, or any dialing key except
STEP 1 Check package contents (mi6896/6895)
Make sure your phone’s packaging includes the following:
Charger power adaptors (3)
Handset
Base unit
Hanging up
Press OFF or place the
handset in its base.
Belt clip
STEP 4 Charge the battery
Base unit
Handsets (4)
Chargers (3)
Telephone line cord
Telephone line cord
Belt clips (4)
Batteries (4)
Wall mount bracket
Quick start guide
1. Place the handset in the base unit/chargers.
2. Charge the battery for at least 16 hours before first use.
Wall mount bracket
Make sure your phone’s packaging includes the following:
User’s manual
STEP 2 Connect power to telephone base/
chargers
Plug the power adaptor into an electrical outlet not controlled
by a wall switch, and the connector into the power jack on
bottom of the telephone base/chargers.
Charger power adaptor
STEP 5 Connect to phone line
Plug one end of the telephone line cord into the telephone line
jack at the bottom of the telephone base. Then plug the other
end of the cord into the wall telephone outlet.
Telephone outlet
AC power outlet
AC power outlet
Telephone line cord
Handsets (2)
Belt clips (2)
Record your outgoing announcement
1. Press SETUP, the system announces “Announcement.
Press PLAY or press RECORD. To continue setup, press
SETUP.”
2.Press REC/MEMO and speak toward the MIC on the base
to record an announcement for up to 90 seconds.
3.Press PLAY/STOP / ( when finished recording).
Charger
Batteries (2)
Wall mount bracket
STEP 8
NOTE:
For complete feature instructions, please refer to your
user’s manual.
STEP 6 Making and receiving calls
Quick start guide
Making a call
• Press
or SPEAKER and listen for dial tone.
Base power adaptor
1. Press TIME/SET to listen to the current setting.
2.Press TIME/SET again to indicate changes needed.
3.Press CHANGE to change the day, hour, minute, or year.
4.When you hear the correct setting, press TIME/SET to
advance to the next setting.
User’s manual
STEP 1 Check package contents (mi6870)
Base unit
Set the Clock
NOTE:
If you have caller ID service, the time will automatically
be updated with the first incoming call after you
program the year into the system.
Quick start guide
Base power adaptor
Base power adaptor
Battery
STEP 7
User’s manual
IMPORTANT!
If your product is not working properly:
1. Refer to your user’s manual.
2. Visit our website at www.vtechphones.com or in Canada,
www vtechcanada.com.
3. Call our customer service at 1-800-595-9511 or 1-800-267
7377 in Canada.
NOTE:
• Use only the power adaptors supplied with your
VTech telephone.
96-006136-020-100
Download PDF