Spillproof Flask Heater K-1/. INSTRUCTION MANUAL FOR for fODVNVPO±:

Spillproof Flask Heater K-1/. INSTRUCTION MANUAL FOR for fODVNVPO±:
INSTRUCTION MANUAL FOR
Spillproof Flask Heater
K-1/.
K- 1for fODVNVPO±:
K-2IRUIODVNVPO±:
PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION
3, Hagavish st. Israel 58817 Tel: 972 3 5595252, Fax: 972 3 5594529 [email protected]
MRC.VER.0-10.1
IMPORTANT SAFETY INSTRUCTIONS
WARNING
1) Do not heat any substances above temperature which will cause hazards of
explosion, implosion or release of toxic or flammable gases arising from the
materials being heated.
2) Do not use in the presence of flammable or combustible materials or explosive
gases.
Do not use in the presence of pressurized or sealed containers.
Fire or explosion may result, causing severe injury or death.
3) To avoid electrical shock, always use a properly grounded electrical outlet of
correct voltage and current handling capacity.
4) The user has the responsibility for carrying out appropriate decontamination, if
hazardous material is split on or inside the equipment.
5) The user shall be aware that, if the equipment is used in a manner not specified
by the manufacturer, the protection provided by the equipment may be impaired.
6) The instrument should be placed so, that handy operation of the ON-OFF Switch
Is possible.
OPERATION INSTRUCTIONS
* Connect the instrument to a ground mains outlet, after ensuring that the Voltage
is the same as given on the name plate. The FLASK HEATER must be connected
to an earthen (grounded) supply.
The Heat controller maintains a set temperature of the heater by turning the power
ON and OFF over short time intervals. The greater the percentage of time the power
is on, the higher the temperature. At the FULL position, power is on continuously and
maximum temperature is obtained. From the OFF position, the knob may be turned
either to the right of left. For fast heatup, turn the knob to Full position. When the
desired temperature is reached, reduce the setting to the point where the
temperature will be maintained. The pilot light is always on when the power is on.
CAUTION : When turning OFF the control be sure the knob is in OFF position and
the indicator light is out.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement