Kambrook KHH100 hair dryer Instruction booklet

The Kambrook KHH100 is a wall-mountable hair dryer that is perfect for use in bathrooms or any other small space. It features 1200 watts of power, three heat and speed combinations, and a removable rear grille for easy cleaning.

PDF Download
Document
Kambrook KHH100 Instruction Booklet | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Wall mountable
  • 1200 watts of power
  • 3 heat and speed combinations
  • Removable rear grille for easy cleaning

Frequently asked questions

Use the wall bracket as a template to mark position of holes for drilling close to electrical outlet, away from bath or vanity basin. Drill three 4.5mm (3/16") holes and insert the anchor bushings by tapping lightly with a hammer until the shoulder of the bushing rests against the wall. Position wall bracket aligned with the holes then tighten the two bottom screws first, then tighten the top screw. Match the slots on the back of the mounting base with the hooks of the bracket. Press into the hooks and slide down to ensure secure mounting. Plug unit into the nearby electrical outlet(230-240 volt AC-50Hz).

To remove the screen simply rotate the screen anticlockwise and loosen. Clean using a toothbrush or similar to loosen lint etc. Turn screen over and wash it in water from a running tap. Towel dry the screen thoroughly. Check the inside screen and if dirty brush gently with a DRY toothbrush.

Line up pages on inside of screen with slots on side of unit and rotate clockwise to lock screen in place.
ALP:
Preparing document for printing…
0%