Federal Signal JetStream Lightbar Product Manual

Add to my manuals
1 Pages

advertisement

Federal Signal JetStream Lightbar Product Manual | Manualzz

256A716

REV. A 500

Printed in U. S. A.

A. GENERAL

INSTRUCTION SHEET

FOR

MODEL AK ALLEY LIGHT KIT

position the reflector assembly over the proper alley light mounting hole (figure 1). Set reflector assembly to desired angle and tighten screw securely (figure 2).

The purpose of this instruction sheet is to supply directions for the proper installation of the Model

AK alley light kit on Federal JetSonic ® light bar

Models JET-012 and JSTRM-012. Alley lights can be installed at both ends of the light bar and are especially useful when illuminating an alley, storefront, etc.

NOTE

After selecting the desired angle, ensure that the alley light reflector assembly does not interfere with the rotating reflector assembly

(while operating).

After unpacking the alley light kit, carefully check all envelopes, shipping labels and tags before removing or destroying them. Ensure that the parts listed in the KIT CONTENTS LIST are contained in the packing carton.

4.

Perform steps 2 and 3 on the other side of the light bar.

KIT CONTENTS LIST

5.

Connect the applicable lead (passenger side

— white with green stripe and driver side — white with orange stripe) to each reflector assembly by connecting the terminal at the end of the lead to the mating terminal at the bottom of the reflector assembly.

Quantity Description

2 Reflector Assembly

Part Number

8552A268

2

2

Lamp, 12V, 50W, #795 8107A119

Tie-Wrap 150A109

6.

Install a lamp (supplied) in each reflector assembly socket.

CAUTION

B. INSTALLATION

1.

Remove the two screws located at the identification plate of each dome assembly. Slide both dome assemblies out of the extrusion.

Do not touch glass portion of lamp. If glass has been handled, it should be carefully cleaned with a grease solvent.

2.

Remove the wire tie-wrap which holds down the existing alley light lead (figure 1). The lead will now be the proper length to reach the alley light assembly — when installed.

7.

Dress the leads from both alley lights with the wire tie-wraps (supplied), in a way which will not interfere with moving parts.

8.

Reinstall the domes removed in step 1.

Secure with previously removed screws.

3.

Locate and remove the 10-32 x 5/16 selftapping screw as shown in figure 1. Use this screw to 9.

Check for proper operation of all functions.

Figure 1.

Figure 2.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement