1 EU Information

1 EU Information
1
EU Information
This product is manufactured in compliance with European Union (EU) Directives and carries the CE
mark. The following information is provided to comply with EU documentation requirements.
NOTE: Products with CE marks perform their required functions safely and adhere
to relevant standards as specified by EC directives provided they are used
according to their intended purpose and that the instructions in this manual are
adhered to. The protection provided by the equipment may be impaired if this
equipment is used in a manner not specified in this manual. Only replacement parts
supplied by PLCDirect or its agents should be used. A listing of international affiliates
is available at our Web site
http://www.plcdirect.com
Technical Support
If you need technical assistance, please call the technical support group at
PLCDirect (3505 Hutchinson Rd., Cumming, GA 30040, U.S.A.) at 800–633–0405.
They are available Monday through Friday from 9:00 A.M. to 6:00 P.M. Eastern
Standard Time. Their Web Site address is
http://www.plcdirect.com
SELV Circuits
All electrical circuits connected to the communications port receptacle are rated as
Safety Extra Low Voltage (SELV).
Environmental
Specifications
Operating Temperature . . . . . . . . . . . . . . . . . . . . . 0° to 50° C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . –20° to 70° C
Operating Humidity . . . . . . . . . . . . . . . . . . . . . . . . 95% (non-condensing)
Air Composition . . . . . . . . . . . . . . . . . . . . . . . . . . . No corrosive gases permitted
Preventative
Maintenance and
Cleaning
No preventative maintenance is required. To clean the exterior of the panel
disconnect the input power and carefully wipe the panel with a cloth moistened with
plain water.
External Fuse
Protection
for Input Power
There are no internal fuses for the input power circuits, so external circuit protection
is needed to ensure the safety of service personnel and the safe operation of the
equipment itself. To comply with EU specifications, the input power must be fused.
Use a fuse rated at twice the input current rating of the panel. For example, if the
panel has an input current rating of 0.5 amperes, use a fuse rated for 1 ampere.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement