12 09-11
12 09-11
1
12 09-11
SUBJECT
DATE
Installation of the Oil Pan
December 2011
Additions, Revisions, or Updates
Publication Number / Title
DDC-SVC-MAN-0081
Platform
Section Title
EPA07/10
Installation of the Oil Pan Oil pan installation is clarified by showing the bolt torque sequence.
DD Platform
All information subject to change without notice.
12 09-11
Change
Copyright © 2012 DETROIT DIESEL CORPORATION
3
2 Installation of the Oil Pan
2
Installation of the Oil Pan
Install as follows:
1. When a plastic oil pan is used, insert the raised lip portion of the seal into the groove in the oil pan. Press down on the
isolator seal and insert it completely around the oil pan. Be careful not to stretch or bunch the seal. For best results, install
the seal at each corner, then at points half way between the corners. Continue in this manner, halving the distance and
seating the seal.
2. For the aluminum oil pan, place the gasket on the top of the pan.
3. Apply 5mm diameter bead of Loctite® 5970 or equivalent to the four corners circled below on the gasket.
4. Install the eighteen oil pan bolts and sleeve assemblies through the pan rail into the holes in the gasket.
5. Ensure the joint surfaces of the gear case, the cylinder block, and front cover are cleaned and there is no damage that could
prevent sealing.
6. Install the oil pan assembly in position on the cylinder block.
NOTICE: Bolt grade must be determined by a marking on the bolt head. Grade 8.8 oil pan bolts cannot be torqued
above 25 N·m (18 lb·ft) or damage to the bolt will occur.
7. Ensure that the seal has not been disturbed. Torque the eighteen oil pan bolt assemblies to 25 N·m (18 lb·ft), using the
proper sequence shown below.
4
All information subject to change without notice.
Copyright © 2012 DETROIT DIESEL CORPORATION
12 09-11
12 09-11
NOTE: The corner bolts on the oil pan will be torqued twice.
8.
9.
10.
11.
12.
13.
14.
Install the oil pan drain plug and torque the plug to 45 N·m (33 lb·ft).
Install bolt at harness P-clip on the front center of the oil pan.
Install the dipstick.
Install the oil filter and cap. Torque to 55 N·m (40 lb·ft).
If oil pump was removed, Refer to section "Installation of the Oil Pump, Oil Suction Manifold, and Oil Lines"
Prime the lubrication system. Refer to section "Priming the Engine Lubrication System"
Refill the oil pan with lubricating oil. Refer to section "Engine Oil Capacities"
WARNING: PERSONAL INJURY
To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface,
parking brake is set, and the wheels are blocked.
WARNING: ENGINE EXHAUST
To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area.
Engine exhaust is toxic.
15. Start the engine and inspect for leaks.
All information subject to change without notice.
12 09-11
Copyright © 2012 DETROIT DIESEL CORPORATION
5
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement