BEA BESAM CUP VER. 6.3,6.4 door control Installation instructions
Below you will find brief information for control BESAM CUP 6.3,6.4. This manual provides instructions on installing and configuring the BESAM CUP 6.3,6.4 control. It covers aspects such as wiring, sensor connections, and programming. The manual also includes troubleshooting tips and contact information for support.
Advertisement
Advertisement
Advertisement
Key features
- Installation guide
- Wiring diagram
- Safety side Q-disconnect
- Control system setup
- LO-21P Parallax II system compatibility
- BESAM CUP VER. 6.3,6.4 control
Frequently asked questions
The Bodyguard Relay Output Function must be changed to #2.
On both controls set PMD functions 20=a, 19=b, 18=00, 17=00, 14=a, 13=a, 12=3 degrees less than F10, 11= 65 degrees.
Inhibiting the Safety Side Superscan (F11) should occur at approx. 65-75 degrees.