Deck-install

Deck-install
DECK SPAN-TRACK
INSTALLATION
SPAN-TRACK ®
Deck Span-Track can be added to any single deep standard pallet rack
(3′, 3′6″, 4′, 4′6″, & 5 ′). Track sections are supported by the front and rear beams.
For each type of carton, install the first level of track following the instructions below
and test for pitch before installing additional levels.
1
2
ADJUST BEAMS
Set front beam to desired
discharge elevation. Set rear
beam at a higher elevation.
Recommended pitch is 1 inch
for every 1 foot of rack depth.
(For example: 4 foot deep rack
would require the rear beam
to be set 4 inches higher than
the front beam.)
ADD TRACK
Track length must match
upright (out-to-out) dimension.
Rear End Stop
with Label Holder *
Front End Stop
with Label Holder *
Rear Beam
Out-to-Out Beam Dimension
Level distance from outside to outside
of front and rear uprights determines
required track length of Deck Span-Track
F nt Beam
Fro
*Labels are
3
TEST PITCH
Test installed track section
for product flow to determine
if rear beam needs readjustment
for effective pitch.
included with
track and are
pre-cut to fit
label holders
IMPORTANT: Track section to be tested should be loaded and
allowed to sit for 24 hours. Then remove cartons at pick face
and check resulting flow. This is the most reliable way to ensure
proper flow for your particular products and storage environment.
See reverse side for High Profile Span-Track installation.
Setting the Standard for Carton Flow
UNEX MANUFACTURING, INC. • 50 PROGRESS PLACE • JACKSON, NJ 08527 • 1-800-695-SPAN (7726) • FAX 732-928-2828 • www.unex.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising