- No category
advertisement
VT73230-2DRDT-R3
VR73230-2DRDT-R3
IFS Fiber Module
Installation & Operation
Instructions
P/N 1062779 • REV B • ISS 01AUG11
VT/VR73230 -2DRDT
OFF
RS232 DATA
ON
1 2
ON
3
2
1
5
4
7
6
Data Input
Data Output
Ground
OFF OFF
RS422 DATA
ON
1 2
3
2
1
5
4
7
6
- Data In
+ Data In
- Data Out
+ Data Out
2-WIRE
RS485 DATA
OFF
ON
1
ON
2
4-WIRE
RS485 DATA
ON
1
ON
2
ON
3
2
1
5
4
7
6
- Data In/Out
+ Data In/Out
NOTE: A 120 ohm resistor (provided) may need to be connected across the data lines to ensure proper operation.
3
2
1
5
4
7
6
- Data In
+ Data In
- Data Out
+ Data Out
NOTE: A 120 ohm resistor (provided) may need to be connected across the data (IN) lines to ensure proper operation.
A
B
C
VT7800A-2DRDT
8 CHANNEL DIGITAL VIDEO TRANSMITTER
+
2 CHANNEL DATA TRANSCEIVER ifs
VIDEO STATUS
CHAN 1 CHAN 5
VT7800B
8 CHANNEL
DIGITAL VIDEO TRANSMITTER ifs
VIDEO STATUS
CHAN 9 CHAN 13 ifs
VT7800C
8 CHANNEL
DIGITAL VIDEO TRANSMITTER ifs
VIDEO STATUS
CHAN 17 CHAN 21
CHAN 10 CHAN 14 CHAN 2 CHAN 6 CHAN 18 CHAN 22
CHAN 3 CHAN 7
POWER CHAN 4 CHAN 8
VT73230-2DRDT
VT7800D
8 CHANNEL
DIGITAL VIDEO TRANSMITTER ifs
VIDEO STATUS
CHAN 25 CHAN 29
CHAN 26 CHAN 30
CHAN 11 CHAN 15 CHAN 19 CHAN 23 CHAN 27 CHAN 31
POWER CHAN 12 CHAN 16
VT73230-2DRDT
CWDM1X5
POWER CHAN 20 CHAN 24
VT73230-2DRDT
POWER CHAN 28 CHAN 32
VT73230-2DRDT
PS-R3
POWER SUPPLY
115VAC - 1A 50/60HZ
220VAC - 1/2A 50/60HZ
POWER ifs
ifs
International
Fiber
Systems
Incorporated
Simplex Single
Optic Cable
A
B
C
Video input from a camera
Power
Video detected from the transmitter
VR7800AX
8 CHANNEL DIGITAL VIDEO RECEIVER
+
2 CHANNEL DATA TRANSCEIVER ifs
VIDEO STATUS
VT VT
CH 1 CH 5
VR VR
RX
A
OFF
1
2
VT VT
CH 2 CH 6
VR VR
TX
RX
B
VT VT
CH 3 CH 7
VR VR
OPTICAL
CARRIER VT VT
CH 4 CH 8
POWER VR VR
TX
1
2
OFF
VR7800B
8 CHANNEL
DIGITAL VIDEO RECEIVER ifs
VIDEO STATUS
VT VT
CH 9 CH 13
VR VR
VT VT
CH 10 CH 14
VR VR
VT VT
CH 11 CH 15
VR VR
OPTICAL
CARRIER VT VT
CH 12 CH 16
POWER VR VR
VR73230-2DRDT VR73230-2DRDT ifs
VR7800C
8 CHANNEL
DIGITAL VIDEO RECEIVER ifs
VIDEO STATUS
VT VT
CH 17 CH 21
VR VR
VT VT
CH 18 CH 22
VR VR
VT VT
CH 19 CH 23
VR VR
OPTICAL
CARRIER VT VT
CH 20 CH 24
POWER VR VR
CWDM1X5 VR73230-2DRDT
VR7800D
8 CHANNEL
DIGITAL VIDEO RECEIVER ifs
VIDEO STATUS
VT VT
CH 25 CH 29
VR VR
VT VT
CH 26 CH 30
VR VR
VT VT
CH 27 CH 31
VR VR
OPTICAL
CARRIER VT VT
CH 28 CH 32
POWER VR VR
VR73230-2DRDT
POWER ifs International
Fiber
Systems
Incorporated
ifs
Status indicating
LEDs will change from RED to GREEN with these conditions.
PS-R3
POWER SUPPLY
115VAC - 1A 50/60HZ
220VAC - 1/2A 50/60HZ
NOTE: WITHOUT PROPER FIBER CONNECTION, LED's DO NOT INDICATE
CORRECT OPERATIONAL STATUS OF THE UNIT.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation.
Changes or modifications not expressly approved by International Fiber Systems, Inc. could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
CLASS 1 LASER PRODUCT
(For purposes of IEC 60825-1)
Complies with FDA Performance Standard for Laser Products
Title 21
Code of Federal Regulations
Subchapter J
Comprehensive
Lifetime Warranty
(a) Seller warrants to the original End User that products and any services furnished hereunder will be free from defects in material and workmanship as of the date of delivery, and will conform to
Seller’s published technical specifications. The foregoing shall apply only to failures to meet said warranties which appear within that period of time during which the Products are installed in their original installation for the original End User and operator of such
Products; provided, however, that in the event of product discontinuance, warranty support is limited to five (5) years from the announcement of discontinuance. Notwithstanding the preceding sentence, the duration of the warranty period for products not manufactured by Seller (e.g., fiber optic cabling, test equipment, power supplies or batteries) shall be the warranty period offered by the original manufacturer, if any.
(b) The conditions of any tests shall be mutually agreed upon and
Seller shall be notified of, and may be represented at, all tests that may be made. The warranties and remedies set forth herein are conditioned upon (a) proper storage, installation, use and maintenance, and conformance with any applicable recommendations of
Seller and (b) Buyer promptly notifying Seller of any defects and, if required, promptly making the product available for correction.
(c) If any product or service fails to meet the foregoing warranties,
Seller shall thereupon correct any such failure either at its option,
(i) by repairing any defective or damaged product or parts of the products, or (ii) by making available any necessary repaired or replacement products or parts thereof. Any repaired or replacement part or product shall be warranted for the remaining period of the original Warranty Period. Seller shall pay, or credit Buyer for, the cost of freight for all return shipments of products or parts to
Buyer. Where a failure cannot be corrected by Seller's reasonable efforts, the parties will negotiate an equitable adjustment in price.
(d) The preceding paragraph sets forth the exclusive remedies for claims based on defect in or failure of products or services, whether the claim is in contract, indemnity, warranty, tort
(including Seller's negligence), strict liability or otherwise and however instituted. Upon the expiration of the warranty period, all such liability shall terminate and BUYER shall have a reasonable time, within thirty days after the warranty period, to give written notice of any defects which appeared during the warranty period. The foregoing warranties are exclusive and in lieu of all other warranties, whether written, oral, implied or statutory.
NO IMPLIED OR STATUTORY WARRANTY OF
MERCHANTABILITY OR FITNESS FOR PARTICULAR
PURPOSE SHALL APPLY. Seller does not warrant any products or services of others which BUYER has designated.
Contacting us
For help installing, operating, maintaining, and troubleshooting this product, refer to this document and any other documentation provided. If you still have questions, contact us during business hours (Monday through
Friday, excluding holidays, between 5 a.m. and 5 p.m. Pacific Time).
Sales and support contact information
North
America
Toll-free: 855.286.8889 in the US, including Alaska and Hawaii;
Puerto Rico; Canada.
Outside the toll-free area: 503.885.5700.
E-mail: [email protected]
Europe
Australia
Select Contact Us at www.utcfssecurityproducts.eu
Note: Be ready at the equipment before calling.
Online
Another great resource for assistance with your Interlogix product is our online publication library. To access the library, go to our website at the following location: http://www.interlogix.com/transmission
1
1.
Many Interlogix documents are provided as PDFs (portable document format). To read these documents, you will need Adobe Reader, which can be downloaded free from Adobe’s website at www.adobe.com
.
Product Disassembly Instructions for WEEE
Per European Directive 2002/95/EC Waste Electrical and
Electronic Equipment
Required Tools:
One number 2 Phillips (crosstip) screwdriver.
One number 2 flat screwdriver.
For the enclosed box version:
1. Locate and remove box cover securement screws. Usually, but not limited to, at least
4 screws.
2. Lift off box top cover.
3. Locate and remove securement screws for printed circuit board.
4. If there are multiple boards to the assembly, continue removing securement screws until none are left.
5. Lift off printed circuit board.
6. Disassembly of box version of product is complete.
For rack version:
1. Locate and remove securement screws for printed circuit board. Usually, but not limited to, at least 4 screws.
2. If there are multiple boards to the assembly, continue removing securement screws until none are left.
3. Lift off printed circuit board(s).
4. Disassembly of rack card version of product is complete.
Copyright © 2011 UTC Fire & Security. All rights reserved.
Trademarks and Interlogix and IFS names and logos are trademarks of patents UTC Fire & Security.
Other trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products.
Manufacturer UTC Fire & Security Americas Corporation, Inc.
2955 Red Hill Avenue, Costa Mesa, CA 92626-5923, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, The Netherlands
Certification
N4131
ACMA compliance Notice! This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
Canada This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme
NMB-003 du Canada.
European Union 2004/108/EC (EMC directive): Hereby, UTC Fire & Security directives declares that this device is in compliance with the essential requirements and other relevant provisions of Directive
2004/108/EC.
2002/96/EC (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European
Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info.
Contact information For contact information, see www.interlogix.com.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project