Methven Waipori Satinjet Slide Rail Shower Shower Installation Guide

CLEANING
Water contains lime which remains on the
surface after the water has evaporated. These
lime deposits can be prevented from forming by
wiping immediately after use.
To clean the chrome-plated surface use a soft
cloth, soap and warm water. Never use cleaning
agents that contain a corrosive acid or a scouring
additive.
Clean filter washer
periodically
Do not use any
shap objects to
clean nozzles
NOTE: Removal of the flow restrictor in the shower rose may be necessary to optimise flow performance in
low or unequal pressure systems only.
Methven warrants this product against manufacturing defects and that it is suitable for use
under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service
New Zealand
0800 804 222
436725
Australia
1300 638 483
USA
1800 975 5409
UK
0800 195 1602
Issue A
WAIPORI SATINJET SLIDE RAIL SHOWER
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min 35 kPa, Max 500 kPa.
Recommended installation of a pressure
limiting valve if supply exceeds 500kPa.
Operating Temperature:
Max 70°C.
NB: New Zealand Building Code Clause G12 Water Supplies specifies all outlets used
primarily for personal hygiene shall deliver
water at a safe temperature.
Inlet Connections: All ½" BSP.
1.
2.
3.
4.
Grubscrew topside
Waipori Handset
Hose
Rail
Soap Dish
Elbow
NOTE: RAIL CAN BE
ORIENTATED SO THAT
HANDSET SITS ON
OPPOSITE SIDE OF THE
RAIL.
Grubscrew underside
Screw
Grub Srew
1850mm (recommended)
NOTE: ENSURE
PROTECTION
PADS ARE USED
BETWEEN WALL
BOSSES AND TILES
Internal Mounting Bracket
Slider
510-645mm
Wall Boss Housing
Secure the wall boss housings in
desired position with 4 screws.
Check the mounts are vertical.
Ensure the grubscrews are located
as shown.
Once located tighten the
screws finger-tight.
Attach the soap dish to
the rail.
Floor
5.
6.
Match the mountings
up to the wall bosses
and push into place.
Slide the rail up and
down if required to
centralise the rail on
the brackets
Fit the internal mounting
brackets by locating in slot
and rotating 90° as shown.
7.
8.
Once satisfied that
the rail is centralised
remove the rail and
tighten the tensioning
screws until they lock.
Relocate the rail
onto wall bosses and
tighten grub screws
top and bottom.
Fit end caps top
and bottom. Ensure
drainage holes are
at back
">