DS6405A ADDITIONAL HANDSET REGISTRATION INSTRUCTIONS This additional handset has been designed to operate with the DS6475-2A telephone system. Please refer to your DS6475-2A user’s manual for instructions on general functionality. Package Contents • 1 DS6405A handset • 1 Charger • 1 AC power adaptor • 1 NiMH rechargeable battery pack Connect the Charger The position in which you place the DS6405A charger could have an effect on the range and performance of your DS6405A. . Plug one end of the power cable into the charger base. 2. Plug the other end into the power wall socket and switch the power on. 2 1 NOTE Ensure power cord is fed through the slot on the charger so unit sits flush with the desk. Install and Charge the Handset Battery . Place the supplied rechargeable battery in the battery compartment, with the battery connector plugged in, as shown above. 2. Slide the battery compartment cover back on until it clicks into place. 3. Place the handset on the charger to charge for at least 16 hours. NOTES • Use only the supplied NiMH rechargeable battery. • If you do not use the handset for a long time, disconnect and remove the batteries to prevent possible leakage. Registering an Additional Handset The additional handset must be registered to the telephone base before use. Follow the instructions below to register a cordless handset to your DS6475-2A. To register a Handset . Make sure the unregistered handset is not on the base or charger cradle. 2. Put the unregistered handset on the base, the screen shows “Registering... Please wait”. The base turns on. The registration process takes up to 90 seconds. indicator on the 3. If the registration is successful , the handset screen shows “HANDSET X Registered” (X stands for the handset number) briefly. The indicator on the base turns off. The handset will return to idle mode. Repeat the steps above if the registration failed. DIGITAL HEADSET CORDLESS PHONE DIGITAL HEADSET CORDLESS PHONE If you have any problems with your phone, refer to the TROUBLESHOOTING section of your DS6475-2A User’s manual. FOR MORE INFORMATION CALL (852) 2667 7433.