Lutron MRF2 8S-DV Wireless Switch, MA-AS 120 V, 277 V, MSC-AS 120 V, 277 V Companion Switch User manual

Below you will find brief information for Wireless Switch MRF2 8S-DV, Companion Switch MA-AS 120 V, Companion Switch MSC-AS 120 V, Companion Switch MA-AS 277 V, Companion Switch MSC-AS 277 V. These devices are capable of controlling various types of lighting, including incandescent, halogen, fluorescent and LED bulbs. They can be set up to work with multiple wireless controllers or sensors and can control loads of up to 950W. The switches can be operated via a tap button or by using the wireless controller.

PDF Download
Document
Lutron Wireless Switch MRF2 8S-DV User Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Control different types of lighting
  • Multiple wireless controllers or sensors setup
  • Up to 950W load control
  • Tap button operation
  • Wireless controller operation
  • Front accessible service switch (FASS)

Frequently asked questions

The maximum load capacity of the MRF2-8S-DV switch depends on the type of load and the installation. For single installations, the maximum load is 950W for halogen/incandescent/electronic low-voltage, 950VA/750W for magnetic low-voltage, 8A for fluorescent and 3A (1/10HP) for general purpose fan. The maximum load capacity is reduced for double and triple installations. See the Derating Chart for specific values.

To set up the Wireless Controller or Sensor to the Electronic Switch, press and hold the Tap Button on the Electronic Switch for approximately 6 seconds. Once the LED starts blinking slowly, release the Tap Button and press and hold the Off Button on the Wireless Controller or Sensor for approximately 6 seconds. The Electronic Switch will then learn the Wireless Controller or Sensor. The LED and load will flash three times to indicate that the set-up mode has been completed.

No, it is not recommended to use these electronic switches to control receptacles, as this can pose a risk of overheating and damage to other equipment.

The maximum wire length between the Electronic Switch and the furthest Companion Switch is 250 feet (76 meters).

The minimum recommended wallbox depth is 2.5 inches (64 mm).
Preparing document for printing…
0%