LIGH

TING & FANS

EC

LAIR

AGES & VENTILAT

EU

RS

CHANDELIER

ICH583A10

10/15

QUESTIONS OR CONCERNS CONTACT CANARM AT:

1-800-265-1833 (English) 1-800-567-2513 (French) Monday through Friday 8:00 AM to 5:00 PM E.S.T.

TOOLS AND MATERIALS REQUIRED:

!

INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS

READ ALL INSTRUCTIONS

IMPORTANT SAFETY

INSTRUCTIONS

SAVE THESE INSTRUCTIONS

Phillips

Screwdriver

Pliers

Wire Cutters

Wrench

Wiring supplies as required by the Canadian

Electrical Code and/or the

Quebec

Electrical code

SAFETY PRECAUTIONS:

1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.

2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE

BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE

HAZARDS INVOLVED.

3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND

WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.

NOTE: Product May Not Look Exactly As Shown In Figures.

INSTALLATION:

at least

12 .5”

Rod(s)

1.

Install the length of rod that is required by threading wire through the rod and screwing it to the fixture.

Install swivel to the rod, ensuring that the sleeve is at the swivel.

WARNING: place light source no closer than 12.5” to any surface.

Studs

“B”

2.

Loosen “B”. Adjust stud to desired length and lock in place with “B”.

Electrical

Box

3.

Mount the mounting bracket to electrical box using electrical box screws

(not included). Make sure the studs on the mounting bracket are facing out from the electrical box.

Mounting

Bracket

Electrical Box Screws

(not included)

House supply

Ground wire

Fixture

Ground wire

Star

Washer

Fixture

Glass

Bulb

Stud

Cap

Nut

Black

White

4.

Connect the ground wires

(bare copper or green) from your fixture to the ground wire

(bare copper or green) or ground screw in the electrical outlet box. Attach the black wire (or wire marked “SPT-1”) from the light fixture to the black wire in the electrical box.

Attach the white wire from the light fixture to the white wire in the electrical box.

5.

Once connections of wires are completed, carefully tuck wires and wire nuts into the electrical box making sure no bare wire (on the black and white) is visible at the wire nuts.

6.

Tuck electrical wires into electrical box and position fixture over studs on mounting bracket assembly. Secure fixture in place with star washer(s) and cap nut(s).

7.

Install specified bulb type and wattage (not included) and glass.

Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: (613) 342-5424, Fax: (800) 263-4598