AND AD-4405 OP-06 Instruction manual

AD-4405-06 OPTIONAL PRINTER INSTRUCTION MANUAL

Installing the optional printer (AD-4405-06)

Note Do not remove any screws other than described below.

When opening the package, check whether all of the following items are included.

Printer cover P rinter unit

Printer board

(a) M3x8

Tapping screw

(3 pieces)

1. Disassembling the indicator

Step 1 Disconnect the power cord from the electrical outlet.

Step 2 Remove the screw that holds the rear panel unit ( ). Loosen the lock screw and remove the rear panel unit ( ), while taking care not to damage the cable.

Step 3 Remove the 4 screws (c) and remove the upper case unit ( ).

Step 4 Disconnect the cable from the board mounted on the upper case unit ( ).

Step 5 Remove the 2 screws (a) and remove the cover ( ) from the upper case unit ( ).

2. Installing the optional printer

(b) M3x6

Screw with washer

(4 pieces) printer board ( ) to the board mounted on the upper case unit ( ).

Step 7 Place the printer board ( ) on the 4 spacers located on the board of the upper case unit ( ). Secure the printer board ( ), using the 4 screws (b).

Step 8 ) from the lower case unit ( ).

Step 9 Secure the printer unit ( ) to the upper case unit ( ), together with the grounding cable ( ) and the interconnect cable ( ), using the 3 tapping screws (a).

3. Reassembling the indicator

Step 10 Connect the cable attached to the rear panel unit ( ) to the board mounted on the upper case unit ( ).

Step 11 Secure the upper case unit ( ) to the lower case unit ( ), using the 4 screws

(c).

Step 12 Secure the rear panel unit ( ) to the lower case unit ( ), using the screw and the lock screw.

Step 13 Attach the printer cover ( ) to the upper case unit ( ).

3-23-14 Higashi-Ikebukuro, Toshima-ku, Tokyo 170-0013 JAPAN

Telephone: [81] (3) 5391-6132 Fax: [81] (3) 5391-6148