SunGlo PSA265 Spec Sheet


Add to my manuals
2 Pages

advertisement

SunGlo PSA265 Spec Sheet | Manualzz

Alfresco-Heating.com

sun glo

The Original Outdoor Patio Heater

R

888-Warm-Glo

Sunglo™ Patio Heaters

The Sunglo™ model PSA265 permanent post heater is an outdoor rated natural gas heater ideal for open patio designs. The in-ground post minimizes the deck space required and positions these heaters at the ideal height for comfort and safety. Heat coverage varies depending on the wind exposure on the patio. The average spacing between heaters is 12 feet apart.

This heater is available with a variety of control systems. Each control system is equipped with 100% safety shutoff. The PSA265 is a manually operated heater requiring no electrical connections. The

PSA265V with solenoid gas valve allows the heater to be turned off/on at the turn of a switch. The

PSA265E offers a completely automated ignition system. Both the PSA265V and PSA265E require an external 24 VAC source.

This heater offers a large deep aluminum disk reflector for maximum comfort, a primary aerated burner for minimal noise, and 100% safety shutoff.

The post is available in a glossy black powder-coat finish or 304 stainless steel.

Specifications:

Overall Height

Input Rating

Fuel Type

Ignition

93 inches

50,000 BTU/HR

Natural Gas

Pilot or Electronic

Electrical PSA265V & E 24 VAC 20 VA

Transformer 24 VAC Not Included

Wind Rating

Nominal Spacing

10 mph Horizontal

12 feet

Manufactured

Certification

Warranty

United States

CSA International

One Year / Parts Only

Mfr. by:

INFRARED DYNAMICS, INC.

3830 Prospect Avenue

Yorba Linda, CA 92886

Toll Free: 1-888-317-5255 www.infradyne.com

Form No 65061-10/07 Printed in U.S.A. Copyright © Infrared Dynamics, Inc. 2007

Alfresco-Heating.com

sun glo

The Original Outdoor Patio Heater

R

Top Clearance

18”

34 ½”Diameter

24” Side

Clearance

12”

Reflector

Radiant Emitter Grid

Pilot Lighting Hole

100% Safety Shutoff Control

Heater Head Base

Slip Collar

3” Dia. Steel Post

½” Gas Pipe

84”

U/L or CSA

Certified Waterproof

Outdoor Junction Box

(Supplied By

Electrical Installer)

7½”Ref.

Ground Level

Under Ground

½”PVC

Plastic Tubing

WARNING

All external piping must be protected against trip hazards.

½” 90 Elbow

Gas Inlet

½” Pipe Coupling

Approved Manual

½” Gas Shut-Off Valve

½”Gas Inlet Pipeline for 50,000 BTU/Hr

12” Minimum

Suggested Specifications:

Heater shall be Sunglo™ model PSA265, PSA265V, or

PSA265E as manufactured by Infrared Dynamics, Inc.,

Yorba Linda, California. All heaters shall be equipped with a control system for use with natural gas fuel.

Each heater shall have passed the ANSI requirements for outdoor heaters.

Reflector shall be of a deep disk circular type mounted on top of heater.

Infrared Radiant Emitter Grid shall be made of perforated stainless steel.

Each heater shall be equipped with a 100% safety shutoff device.

888-Warm-Glo

Sunglo™ Patio Heaters

PSA265 heaters require no electrical connection and are the easiest to service and maintain. This heater utilizes a pilotthermocouple 100% safety shutoff. Pilot must be manually lit.

Heater is turned off/on with a manual control knob located at the front of the heater.

PSA265V heaters require 24 VAC electrical to be connected in order to operate the main burner. This heater utilizes a pilot-thermocouple 100% safety shutoff. Pilot must be manually lit. Heater is turned off/on with electrical switch, timer or other control device by interrupting the 24 VAC supply to the heater. Control device is to be supplied by the installer. Manual control knob must be set to the ON position for this heater to operate with an electrical switch.

PSA265E heaters require 24 VAC electrical to be connected in order to operate. This heater utilizes an electronic ignition and monitors the heater through flame rectification. Heater cannot be manually lit. Heater is turned off/on with electrical switch, timer or other control device by interrupting the 24

VAC supply to the heater. Control device is to be supplied by the installer.

The required clearance from combustible materials must be maintained on all heaters. In addition heaters must have adequate fresh air and ventilation to operate properly. Make sure you can meet these requirements in making your heater selection.

This specification sheet was designed as a brief summary about this heater. The primary use of this sheet should be for heater selection only. It should not be used as the sole guide in placement and installation of these heaters. Complete installation instructions can be obtained by calling toll free at

1-888-317-5255 and online at www.infradyne.com.

SUGGESTED SPACING WHEN

MULTIPLE HEATERS

ARE USED:

15 Ft.

15 Ft.

Spacing For - WELL PROTECTED AREAS

AND MILD CLIMATIC CONDITIONS

12 Ft.

12 Ft.

Spacing For - SEMI EXPOSED AREAS

WITH AVERAGE WEATHER CONDITIONS

8 Ft.

8 Ft.

Spacing For - COMPLETELY EXPOSED AREAS

WITH SEVERE WEATHER CONDITIONS

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement