CH-100 Serial Port Update Procedure (PDF File Format).

CH-100 Serial Port Update Procedure (PDF File Format).
Revised September 21, 2010
CH-100 HUB Serial Port Update Procedure
1. Turn off power to the CH-100.
2. Place ALL four Dip Switches to the ON position.
3. Turn on power and note that the front panel LEDs (except the power LED) should alternately
cycle on/off for a short period of time. This indicates entry into the bootloader.
4. Load the LMI Flash Programmer installed on your computer. Set as follows:
PLEASE NOTE.
Set COM port to
your active com
port.
CH-100 Serial Port Update Procedure.docx
Page 1
Revised September 21, 2010
5. Click the “Program” tab and set as follows:
PLEASE NOTE.
Program offset
must be 1000.
6. Click the Browse button and select the new program “bin” file. The letter “U” will denote an
update file.
7. Under Erase Method, select Erase Necessary Pages.
8. Set program offset to 1000.
9. When ready, click the Program button.
10. When programming, please note the flickering “RED” LED to indicate update activity.
11. After programming has completed remove power.
12. Return the Dip Switches to your previous settings and re-apply power.
CH-100 Serial Port Update Procedure.docx
Page 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising