Preamp Power Supply

Preamp Power Supply
PRODUCT MANUAL
PRE A M P POW E R S U PPL Y
This power supply fits all K&K battery powered
preamps. Unlike standard, less expensive power
supply adapters, this power supply is silent – it will
not hum!
With this unit, you can save batteries and get better
performance out of your preamp's circuit. The power
supply delivers 12 volts (instead of 9 volts from a
battery), which results in better headroom, more
clarity, lower distortion, and lower noise.
This power supply is especially beneficial for all
K&K Dual Channel Preamps (Trinity, PowerMix Pure
XT, Bass Master Rockabilly, Bass Master Pro, and
Dual Channel Pro Preamps) due to their relatively
high power consumption.
It works on 120 volt USA and 220 volt European
power (with a simple travel adapter). Use the power
supply whenever you do not need the freedom of
movement that battery operation provides.
It simply hooks up to the battery clip, instead of the
battery. The thin and extra-rigid 3/32" cable exits
the preamp on the in/output-jack side between lid
and rear panel. The new K&K Dual Channel Preamp
models even have a little notch for the cable above
the center jack (see picture). We use this thin cable
for the first 5 feet so that it doesn’t weigh down the
preamp and so that you can use it with any existing
K&K preamp (even without the notch on the rear
panel).
TECHNICAL INFORMATION
Input voltage: 100 -220 volt
Input plugtype: USA
Output voltage: 12 volt DC /100 mA
Output connector: battery clip
Dimensions: 3.3/4" L x 2 3/8" W x 1 1/4" H
Cable length: 10 feet (5 feet 1/4" plus 5 feet 3/32")
Type: Fully filtered with noise and hum free DC
output
92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541-888-3517 | Toll Free 1-800-867-6863 | www.kksound.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement