DIN RAIL MOUNTING KIT KB PART # 9995 INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS
DIN RAIL MOUNTING KIT KB PART # 9995
Mounting Clip
The Din Rail Mounting Kit can be used
with the following KB controls:
KBIC, KBMM, KBMG, KBVF, KBWD, KBTC.
The Din Rail Mounting Kit consists of:
DESCRIPTION
e
at
Mounting Plate
º
90
t
Ro
NO. PCS.
Mounting Plate
1
Mounting Clip
2
10–32 x 1/2 Screw
2
Figure 1
Caution: Do not overtighten mounting plate screws.
I.
STANDARD MOUNTING
Instructions: The mounting plate
can be positioned across the short
side of the "L" bracket of the speed
control as shown.
Figure 2
A) Horizontal mounting,
use (2) mounting clips
supplied. See figures
1 and 2.
B) Vertical mounting:
Use one (1) mounting
clip as shown
in figure 3.
Figure 3
II. ALTERNATE MOUNTING
An alternate mounting
method (see figure 4) is to
position the Mounting
Plate on the long side of
the "L" bracket. Either set of mounting slots can be used.
Figure 4
KB ELECTRONICS, INC.
12095 NW 39th Street, Coral Springs, FL 33065-2516 • (954) 346-4900 • (954) 346-3377
Outside Florida Call TOLL FREE (800) 221-6570 • E-mail – [email protected]
www.kbelectronics.com
A40098 – Rev. A – 10/99

Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project