Tech Bulletin 032
TECHNICAL SERVICE BULLETIN
BULLETIN NUMBER:
B132/B200 – 032
06/23/2006
APPLICABLE MODEL:
GESTETNER – DCS460/CS555
LANIER – LC160/LD155
RICOH – AFICIO 3260C/AFICIO COLOR 5560
SAVIN – SDC6045/SDC555
SUBJECT: WHITE LINE IN SOLID IMAGE AREA
A white line [A] appears along the paper feed direction, in solid image areas that use only one toner color
(C, M, Y or K).
[A]
Paper Feed Direction
CAUSE:
Dust or other foreign particles get into the development unit, and then get stuck between the doctor blade
and the development sleeve.
SOLUTION:
When the symptom occurs:
1. Remove the developer from the development unit(s) that show the symptom.
2. Remove the extra toner and developer from the development unit(s) with a vacuum cleaner.
3. Install the new developer.
When you install the developer cartridge or replace the developer, make sure the developer cartridge is
placed on a clean surface.
Copyright  2006 RICOH Corporation. All rights reserved.
www.ri co h univ er sity .co m
Page 1 of 1
COPY QUALITY
SYMPTOM:
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising