Quick Start Up Guide for GateGuard w/Keypad

Quick Start Up Guide for GateGuard w/Keypad
Quick Start Up Guide for GateGuard w/Keypad
Congratulations on your purchase of Ritron’s “RGG1” GateGuard w/Keypad Kit.
This short quick start guide will help simplify your installation.
Ritron’s GateGuard w/Keypad Kit enables you to wirelessly and remotely
activate any gate, door, or any other piece of equipment that has a motorized
operator.
Kit Contents:
Make sure your package includes all of these items:
1) RQX-XT-KP Callbox w/Keypad
1) RPS-EXPO Power Supply for the Callbox
1) JBS Base Station Radio
1) JBS-MMK Base Station Mounting Bracket
1) JMX Handheld Radio
1) BCJS-AD Drop-In Charger for the Handheld Radio
RPS-EXPO
RQX-XT-KP Callbox w/Keypad
BCJS-AD
JBS -MMK
JBS Base Station
JBX Handheld
Steps to Ensure Ease of Installation:
• Unpack all of the items.
• Charge the Handheld Radio using your drop-in charger for 16 hours to
ensure full charge of the battery.
• Unscrew the fasteners of the Callbox faceplate and open the internal
box to install the Ni-Cad rechargeable D-Cell batteries or standard
alkaline D-Cell batteries.
• If rechargeable batteries are being used, be sure to change the charge
jump switch to the “ON” position. See callbox manual.
• Drill hole in the bottom or the back of the callbox to run the power and
switch closure wires into the callbox.
Installing Your System:
Installing your Base Station
1) Plug your Base Station’s power supply (RPS-1A) transformer into a
standard 120VAC outlet and plug the male end of the power supply
into the back of your Base Station.
2) Turn your Base Station on and turn to Channel 1 to communicate to
your callbox and handheld radio.
3) If you choose to mount the Base Station to a wall, you should first
install the mounting bracket (JBS-MMK) on the wall and then connect it
to the Base Station using the existing screws on the side of the Base
Station.
Installing your Callbox
1) Mount your callbox to a wall, gooseneck, or post using either the
included mounting flanges or optional Callbox mounting plate (RQXXTMK, contact Ritron for details)
2) Connect the Red and Black wires from the callbox to your power
supply, (RPS-EXPO). This is included with your GateGuard Kit
3) Connect the Blue and Green wires from the callbox to your Gate
Operator’s switch output wires.
4) After wiring your callbox to your existing Gate Operator, be sure to seal
the hole to ensure it’s weather resistance, this is usually done with
conduit.
Installing your Keypad
1) Keypad is pre-installed (see callbox manual for programming
instructions)
Using your new GateGuard System
Keypad
• To open gate with Keypad, simply enter the pre-authorized code.
Intercom
• To communicate from one radio to another simply press the push-totalk button on the Handheld, Base Station, or Callbox radio. Release
PTT to listen.
• To activate the gate from Handheld Radio press and hold the channel
button until the activation tone is complete. To use the Base Station to
activate the gate simply press and release the Z-Button. (See button
location below).
• To turn off the handheld radio and base station radio, push and hold
the “OFF” button.
Call Ritron with any questions at 800-872-1872.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement