Control Box Installation/Care Guide

Control Box Installation/Care Guide
Preventing Control Damage and Failure
Control Boxes Are NOT Water Tight
•
•
Clean with a soft damp cloth only
CAUTION – Excessive water will cause failures
•
•
•
Do not power wash
Do not hose down
Do not use excessive
water when cleaning
Installation
•
•
•
•
Always mount vertically, do not mount horizontally
Use included screws, Don’t use alternate hardware
Do not over tighten
Do not use lockwashers
Over Tightening Causes Failures
•
•
•
Lock Washer Damage
Insert Ethernet cable straight into RJ-45 connector
Strain relieve cable so that connector entry remains
straight
Route and protect cable to prevent damage/pulling from
behind/under counter installations/storage
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising