Material Safety Data Sheet MV-5 Fuel System Cleaner Emergency Telephone #: CHEMTREC (24 hours) 1-800-424-9300 (US only) or (703) 527-3887 outside US 1. Chemical Product and Company Identification Product Name: MotorVac MV-5 Description: Gasoline Engine Fuel System Cleaner, Part # 400-0050 Company Identification: MotorVac Inc. 1324 Blundell Road Mississauga, Ontario, Canada L4Y 1M5 (905) 615-8620 (for inquiries only) Issue Date: January 12, 2012 2. Composition/Information on Ingredients Chemical Name CAS Number Light Petroleum Distillates Light Aromatic Naphtha Oleic Acid Methyl Isobutyl Carbinol (mixture) 64742-95-6 112-80-1 108-11-2 Ethylene glycol monobutyl ether 111-76-2 1, 2, 4-Trimethylbenzene 95-63-6 Ammonia Solution 1336-21-6 Propane 74-98-6 %W 40-60 <15 < 10 <10 <10 1-5 1-5 <10 3. Hazards Identification WHMIS Classification: HIMS Rating - A, Compressed Gas B5, Flammable Aerosol D2B, Toxic Material Health: Flammability: Reactivity: PPE: 2 4 1 B Emergency Overview: Extremely flammable aerosol. Harmful if swallowed. May cause lung damage if swallowed. Causes skin and eye irritation. High concentration of vapour may cause nausea, dizziness, headaches and drowsiness. Contents under pressure. Primary entry route(s): Inhalation, Ingestion, Eyes and Skin. Effects of short-term (acute) exposure: (for more details, refer to Section 11). Potential Health Effects Eye: Contact will cause irritation. Liquid may cause temporary pain if splashed in the eye(s). May cause redness, tearing and moderate irritation. Skin: Prolonged or repeated contact will cause skin irritation. If trapped against the skin for a long period (probably more than 30 minutes), serious irritations, even burns and skin loss may occur. Inhalation: Vapours may cause respiratory irritation. Breathing vapours at concentration above recommended exposure limits could cause headache, dizziness, nausea and drowsiness. Vapours may cause central nervous system (CNS) depression. Other CNS effects such as headache, lack of appetite, drowsiness, and in-coordination can occur. Very high concentrations may cause unconsciousness and pulmonary edema. Ingestion: If swallowed, this material may irritate the respiratory tract. Due to its low viscosity, there is danger of aspiration into the lungs during swallowing and subsequent vomiting. Aspiration can result in severe lung damage. Product is moderately toxic if ingested. It may cause burning in the mouth, throat and chest as well as stomach irritation, nausea, and vomiting. Central nervous symptom depression, such as unconsciousness and coma, can occur. Inhalation of product into the lungs (aspiration) can occur while product is in the mouth, being swallowed or during vomiting. The aspiration of even a small amount of product into the lungs is very hazardous and may cause death. Aspirated product can cause chemical pneumonitis and/or pulmonary edema. Medical Conditions Aggravated by Long-term Exposure: Repeated or prolonged contact can dry the skin and cause cracking, irritation and dermatitis. 4. First Aid Measures Eye Contact: In case of contact, immediately flush eyes with plenty of water for at least 15 minutes while holding eyelids open. Get medical attention if irritation develops or persists. Skin Contact: Remove contaminated clothing and wash affected area immediately with large amounts of soap and water. Get medical attention if irritation develops or persists. Inhalation: Remove source of contamination or move the exposed person to fresh air. If not breathing, trained personnel should give artificial respiration. Get medical attention. Ingestion: Do Not induce vomiting. Contact a physician. Never give anything by mouth to an unconscious person. If swallowed, immediately give 2 glasses of water. 5. Fire Fighting Measures COC Flash Point: 20C 6 oC (42.6 oF) ( lowest component ) Autoignition Temperature: Not Available Flammable Limits in Air: LEL (% by volume): Not Available UEL (% by volume): Not Available Extinguishing Media: Use dry chemical, carbon dioxide, foam or water fog. Water may be ineffective since it may not cool the material below its flash point Fire & Explosion Hazards: Material probably not sensitive to mechanical impact. Vapour can be readily ignited by static charge. Fire Fighting Instructions: Flammable liquid and vapour. This material releases vapours at or below ambient temperatures. When mixed with air in certain proportions and exposed to an ignition source, its vapour can cause a flash fire. Vapours are heavier than air and may travel long distances along the ground to an ignition source and flash back. Liquid can float on water and may travel to distant locations and/or spread fire. If container is not cooled, it can rupture in the heat of the fire. As in any fire, wear self-contained breathing apparatus pressure-demand MSHA/NIOSH (approved or 1 MV-5 equivalent) and full protective gear. Avoid breathing smoke, fumes and decomposition products. Hazardous Combustion Products: In the case of a fire, oxides of carbon, oxides of nitrogen, hydrocarbons, trace elements, fumes and smoke may be produced. 6. Accidental Release Measures Safeguards (Personnel): Wear appropriate personal protective equipment. Eliminate all sources of ignition in the vicinity of the Spill. All equipment used when handling this material must be grounded. See Section 8. Large Spills Procedure: Contain spilled material. Large spillage should be dammed-off. Prevent spilled product from entering stream or drinking water supply. Pick up free liquid if it can be safely done with explosion-proof equipment. Take up the remainder with absorbent material. Treat or dispose of waste material in accordance with all local, state/provincial and federal regulations. Small Spills Procedure: Absorb spills with inert material. Avoid disposal into wastewater treatment facilities. Treat or dispose of waste material in accordance with all local, state/provincial and federal regulations. 7. Handling and Storage Handling (Personnel): Do not get into eyes, on skin or clothing. Use only with adequate ventilation and personal protection. When sampling containers use appropriate personal protective equipment. When handling material use spark-proof tools and explosion-proof equipment. Storage Requirements: Always keep containers tightly closed and do not handle or store near heat, sparks or any potential ignition sources. Store away from incompatible materials such as strong oxidizers. Protect containers from physical damage. 8. Exposure Controls/Personal Protection Engineering Controls/Ventilation: Good general ventilation should be sufficient to control airborne levels. An emergency eye wash station and safety shower should be located near the workstation. Eye/Face Protection Requirements: Wear splash-proof safety glasses. Skin Protection: Wear protective gloves to minimize skin contamination. For brief contact, normal work attire should be sufficient. When prolonged or repeated contact could occur, use protective clothing impervious to this material. Respiratory Protection Requirements: Under normal use conditions while handling small quantities, with adequate ventilation, no special handling equipment is required. 9. Physical and Chemical Properties: Appearance…………………………: Aerosol , Clear Amber Odour……………………………….: Aromatic with ammonia Water Solubility…………………….: Partial Boiling Point …….…………………: Not Available Vapour Density (Air =1)…………….: >1 Vapour Pressure……………………..: Not Available Specific Gravity ……………………..: 0.8 – 0.85 @ 15oC Odour Threshold…………………….: Not Available pH……………………………………: Not Available 10. Stability and Reactivity Chemical Stability: Stable under normal conditions of storage and use. Conditions to Avoid: Avoid contact with strong oxidizers (e.g. peroxides, nitric acid and perchlorates). Avoid heat, sparks, static discharge, friction, open flames and other sources of ignition. Hazardous Polymerization: Will not occur Hazardous Decomposition Products: Decomposition will not occur if handled and stored properly. 11. Toxicological Information Not Available No Components are listed as carcinogens by ACGIH, IARC, OSHA or NTP. 12. Ecological Information Environmental Effects: Not Available Important Environmental Characteristics: Not Available Aquatic Toxicity: Not Available 13. Disposal Information Waste Disposal: Unclean empty containers should be disposed of in the same manner as the contents. Avoid washing material into sewer systems without proper treatment and authorization by the treatment facility management. Treat or dispose of waste material in accordance with all local, state/provincial and federal regulations. 14. Transportation Information Transportation of Dangerous Goods Information for TDG, DOT (49 CFR), by Ship (IMDG Code): Proper Shipping Name AEROSOLS, : FLAMMABLE Class: 2.1 Identification number: UN 1950 LTD QTY, ORM-D (503 ml/can) Transportation of Dangerous Goods by Air (ICAO/IATA): Proper Shipping Name: AEROSOLS, FLAMMABLE Class: 2.1 Identification number: UN 1950 15. Regulatory Information Miscellaneous Information: This material or all of its components are listed on the Inventory of Existing Chemical Substances under the Toxic Substance Control Act (TSCA) and the Canadian Domestic Substance List (DSL). 16. Other Information Reason for Issue..….……………….: New Approval Date............…………........: January 12, 2012 Additional Information: The data in this Material Safety Data Sheet relates only to the specific material designate herein. It does not relate to use in combination with any other material or in any process. Disclaimer of Liability: The information is furnished without warranty, expressed or implied, except that it is accurate to the best 2 MV-5 of our knowledge and belief. However, since the conditions of handling and use are beyond our control, we make no guarantee of results, and assume no liability for damages incurred by use of this material. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist. It is the responsibility of the users to comply with all applicable federal, state/provincial and local laws and regulations. 3 MV-5
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021