Proove EL2650 User manual

[ENGLISH] USER MANUAL
for your own safety
• Read all instructions before using the fan heater.
• Only connect the fan heater
to a single-phase socket with
a main voltage as specified on
the rating plate.
• This appliance meets the
electromagnetic compatibility
requirements specified in BN
551004/95 with regard to interference with radio and TV sets.
• Do not leave your home while
the appliance is in function:
ensure that the switch is in OFF
(O) position and the thermostat are in minimum position.
Always unplug the appliance.
• Keep combustible material
such as furniture, cushions,
bedding, paper, clothes, curtains etc. at last 100cm away
from the fan heater.
• Do not hang anything on or in
front of the fan heater.
• Always unplug the heater
when not in use. Dots not pull
the cord to unplug the heater.
• Keep the air inlet and outlet
free from objects: at last 1m
in front and 50cm behind the
heater.
• Do not install the heater right
below a socket.
• Do not let animals or children
touch or play with the fan
heater. Pay attention! The air
outlet gets hot during operation (more than 80°C, or 175°F).
• Do not cover. If covered, there is
the risk of overheating.
• Do not use this fan heater in
the immediate surroundings of
a bath, a shower or a swimming pool.
• Do not use the fan heater in
the rooms with explosive gas
or while using inflammable solvents, varnish or glue.
• If the cord of this appliance is
damaged discontinue use of
this product and contact your
retailer for further instructions.
• Keep the fan heater clean. Do
not allow any objects to enter
any ventilation or exhaust
opening as this may cause
electric shock, or fire or damage
to the heater.
installation
The appliance requires no installation; it should be used solely
as a portable appliance. Portable
appliances are not suitable for
use in a bathroom.
operation
• Turn the thermostat knob in
a clockwise direction until it
reaches the maximum setting.
• Summer service (ventilation
only): turn the knob to setting
• Heating at reduced power: turn
the knob to setting I (1000W).
• Heating at full power: turn the
knob to setting II (2000W).
• Switching off: turn the knob to
setting O.
[ENGLISH] USER MANUAL
regulating the thermostat
When the room has reached
the required temperature turn
the thermostat knob in an
anti-clockwise direction up to
the point where the appliance
switches off and not beyond. The
temperature fixed in this way
will be automatically regulated
and kept at a constant level by
the thermostat.
cleaning and maintenance
Before cleaning always remove
the plug from the electrical
socket. Clean the air inlet/outlet
grilles frequently. Never use
abrasive powders solvents.
warnings
• Do not use the appliance in the
vicinity of showers, bath tubs,
wash basins, swimming pools,
etc.
• Always use the heater in an
upright position.
• Do not use the heater to dry
your laundry.
• Never obstruct the intake and
outlet grilles (danger of overheating).
• The heater must be positioned
at last 100 cm from furniture or
other objects.
• This appliance comes with a
Y-type connection. Replacement of the feed cable must be
entrusted to a technician only,
because such work requires
special tools.
• The appliance must not be
positioned directly underneath
a fixed power point.
• Do not use the appliance while
it is cooling down, in order to
avoid overheating with the attendant risk of fire.
• Do not use the appliance in
rooms less than 4 m2 area.
• The heater is fitted with a safety device which will switch off
the heater in case of accidental
overheating (or. Obstruction
of air intake and outlet grilles,
motor turning slowly or not
at all).
• To reset, disconnect the plug
from the power for a few
minutes, remove the cause of
overheating then plug the appliance in again.
technical data
Maximum rate power......2000 W
Power range........ 0/1000/2000 W
Voltage......................... 230V~50 Hz