Page 1 The Digital Upgrade Kit transforms the Recycling Net System

Page 1 The Digital Upgrade Kit transforms the Recycling Net System
DIGITAL UPGRADE KIT
INSTALLATION & OPERATION INSTRUCTIONS
PREPARATION
1
First detach both Side Nets from your table net.
Then unplug the Connector Cable from the back of
the robot (see Step 8 for illustration).
2
5
Locate the RoboPong 2050 robot
body in the
Up­grade Kit.
6
Loosen the two Wing
Nuts that hold your current robot body onto the
Center Trough. If your
robot has the black, rectangular
Clip Washers (instead of the
round gold-colored washers),
you will also need to rotate the Clip Washer 180˚.
7
Pull straight up on the robot
body to remove it from the
Center Trough. You may keep
your old robot body, there is
no need to return it to Newgy.
8
Take your new Robo-Pong 2050 robot body and
mount it in the Center Trough. Be sure that the new
robot body fits fully down on the locating tab of the
Center Trough. Finally, retighten the Wing Nuts.
➦
4
Unhook the robot
from the table and
place the robot on
top of the table.
Place it with the robot facing you for easy access.
➨
3
Push all the balls in
the Center Trough up
into one of the Ball
Trays and then insert a
Ball Dam to prevent the balls
from rolling back into the
Center Trough. (See page 17 of
the Owner’s Manual included
with your kit for more info on Ball Dams).
➥
Detach the sides of
your Trap Net (the
black net with big
holes) and flip it over
the top of the main net to get
it out of the way.
REPLACE THE ROBOT BODY
➥
The Digital Upgrade Kit transforms the Recycling Net
System of a 2000 or 2040 into a 2050. You will retain your
current net system. The complete robot body and entire electrical system is replaced. Instal­lation is easy and fast. Pictures
below show installing an upgrade on a Robo-Pong 2040.
This kit can also be used to upgrade a 1040 into a 1050.
Installation is even easier and faster. The Ball Feed Collector
Plate (#41 on page 47 of the included Owner's Manual) must be
removed before mounting the robot body on your Ball
Bucket. After detaching the Collector Plate, simply remove
the old 1040 Robot Body from the Ball Bucket and then
install the new digital robot body in the bucket.
9
Reinsert the Con­
n ector
Cable into the robot. Pull
out the Ball Dam to release
the balls so they roll back
into the Center Trough. Reposition
and reattach the Trap Net and Side
Nets.
➨
WARNING: Newgy digital robots can only use 40mm balls.
Use of other-sized balls, including 38 and 44 mm is not supported. If you want to use 38mm balls, we suggest you keep
your 2040 parts and reinstall them whenever you need to practice with 38mm balls.
1
2
4
➨
5
6
7
8
➦
3
➥
➥
9
➨
1
2
4
➨
5
Déballez le kit
d’adaptation
2050.
6
7
8
➦
3
➥
➥
9
➨
INSTRUCCIONES DE INSTALACIÓN Y FUNCIONAMIENTO
PREPARACIÓN
1
2
4
➨
5
6
7
8
➦
3
➥
REEMPLACE EL CUERPO DEL TIRADOR
➥
9
➨
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising

Languages

Only pages of the document in English were displayed