Dry Vacuum Cleaner with Water Filter
Aspirapolvere di filtrazione dell’acqua per uso secco
Aspiradora Seca con Filtre de Agua
Aspirateur sec avec filtre à eau
Пылесос с аквафильтром сухой уборки
Návod k obsluze pro ARNICA BORA 5000 Vysavač s vodním filtrem
A4
B5
B4
B6
D5
A3
B2
A6
A1
B1
A8
C1
A2
C2
B3
A5
A7
C4
D1
C3
D2
D4
D3
2
D6
C5
3
4
5
6
7
ARNICA BORA 5000 DRY VACUUM CLEANER
WITH WATER FILTER
Thank you for choosing our product. This instructions manual
has been prepared for you to achieve complete satisfaction
and maximum performance from your product READ THESE
INSTRUCTIONS CAREFULLY BEFORE USING THE APPLIANCE
AND KEEP THE MANUAL FOR FUTURE REFERENCE.
CONTENTS
1. IMPORTANT SAFETY & USAGE INSTRUCTIONS
2. GENERAL DESCRIPTION
3. PREPARING FOR USE
4. USING THE APPLIANCE
5. CLEANING & MAINTENANCE
6. TECHNICAL SPECIFICATIONS
1. IMPORTANT SAFETY & USAGE INSTRUCTIONS
• Check if the voltage indicated on the type plate sticker
(located under the wheel group) corresponds to the local
mains voltage before you conect the appliance.
• The appliance should only be connected to power outlets
which are suitably with minimum 10 Amp fuse.
• Do not insert the mains plug into the wall socket until the
appliance is completely ready for use.
• Always remove the mains plug from the wall socket when
you are not operating the appliance.
• Appliance musn’t be used if the cord or plug is damaged,
if any defects are present of if you have dropped the unit or
have broken any of its parts. I such cases, you must take it to
a service center to be checked, repaired or adjusted.
8
• Do not allow the appliance to pass over the cable as this
may damage the insulating shield.
• Keep the appliance out of reach of children
• Never use appliance without the foam filter
• Never immerse the motor unit in water
• Do not attempt to use the appliance if it appears to be
defective.
• Always switch the appliance off after use and remove the
mains plug from the wall socket.
• Always empty, clean and dry container after wet use. Let
the appliance suck in dry air for few minutes to dry the inside
of the tubes and hose. This prevents unpleasent smell and
prevents the paper dust bag from becoming wet.
• Do not point the hose at the eyes or ears nor put it in your
mouth when the appliance is switched on.
• Take particular care when cleaning stairs.
• Switch off immediately in the event of leaking liquid .
• Use only original accessories and spare parts to ensure the
perfect performance of your cleaner and to benefit from the
guarantee.
• For repairs or spare parts, contact your local service agents.
ATTENTION: Please do not use any foaming
products as a water additive.
• Please pay attention to the water in the container during
the suction phase. If this begins to foam, switch off the
device and renew the water as otherwise component B5 will
suck in moisture and the motor can be damaged.
• Foam forms mainly during prolonged use and when the
water is very dirty or because the vacuum cleaner has sucked
in residue from carpet cleaner or hard floor surfaces.
WARNING: Never use the appliance to clean up
flammable or explosive solvents, object soaked with
such solvents, explosive dusts, liquids such as petrol, oil, alcohol, thinners and objects that are hotter than 60 oC, as this
will cause a serious explosion and fire hazard! The appliance
must not be used near flammable substances and must not
be used to clean up health endangering dust.
WARNING: Only perform dry vacuuming with your
vacuum cleaner.
2. GENERAL DESCRIPTION
Main parts of the appliance are shown as follows (Figure 1)
A. MOTOR UNIT
This group contains motor, switch and operating units on. Top
of this group, there is a HEPA FILTER which filters dust and
other particles from blowing air.
A1 ON-OFF / suction power regulation switch
A2 Cord rewinder button
A3 Hepa Filter
A4 Hepa Filter housing cover
A5 Suction inlet
A6 Body handle
A7 Extra soft rubber wheels
A8 Clamp housing
B. CONTAINER GROUP
Container Group is for collecting dust and dirty water. This
group is placed on the Body group.
B1 Transparent Water tank
B2 Cover of the Transparent Water tank
B3 Handle of the Transparent Water tank
B4 Water Filter Body
B5 Water filter tube
B6 Motor air inlet grille
C. THE HOSE GROUP
This group contains suction hose with hand grip and suction
tubes. Suction nose is connected to container group by
inserting the suction hose into the suction inlet. Suction
tubes are connected to hand grip if necessary. Handgrip
contains a manual sliding for regulating suction power.
Hose group can be placed onto the motor unit by the help
of hanger.
C1 The elastic suction hose
C2 Telescopic pipe
C3 Main brush
C4 Turbo brush
C5 Hand Turbo brush
D. ACCESSORIES GROUP
There are various accessories for different cleaning purposes.
D1 Accessories Holder
D2 Crevice Nozzle
D3 Round Nozzle
D4 Small Nozzle
D5 Air Freshener
D6 Hard flooring nozzle with horse hair
3. PREPARING FOR USE
ATTENTION: Do not insert the mains plug into the
wall socket until the appliance is completely ready
for use.
• Lift the Reservoir Group and put aside by holding from its
handle.
• Remove the water filter tube and Water Filter Body by
pulling after you open the reservoir cover.
• Check the parts and accessories in the Operating Manual
with the ones you take out of the Tank. Check whether they
are missing or damaged.
• If you will use your vacuum cleaner immediately, add
water in the Transparent Water Tank in accordance with the
maximum level (Maximum 1.2 liter) indicated on the Tank.
• Drop 2 or 3 drops of perfume supplied with your vacuum
cleaner into the water for providing your room’s air smells good.
• Replace the Water Filter Body and water filter tube to their
places in the Transparent water tank. Make sure that the
Engine Air Inlet Grille connected to Engine Air Inlet Neck. If it
is not, please connect it. Then connect Engine Air Inlet Neck
to your vacuum cleaner. Close the chamber cover. Replace the
water tank Cover.
• Replace the Transparent Reservoir Group on the main Body
tightly.
• In order to connect the Hose Group to the Main Body Group,
place the Vacuum Head of the Hose on to the Vacuum Head
on the tank.
WARNING: Do not ever vacuum wet floors or water
from sink. Only perform dry vacuuming with your
vacuum cleaner.
4. OPERATING THE APPLIANCE
• Perform the Assembly and Preparation for Use processes.
• Choose the most appropriate accessories for your purpose
and affix these accessories directly on the gun section or affix
the Extension tubes first and then accessories on their ends.
• For an effective cleaning, use the accessories as mentioned
in the following.
Main brush for vacuuming carpets, rugs and hard grounds.
Crevice nozzle for cleaning the dusts, chips and etc. at
radiators, drawers and etc. narrow sections.
9
Directly the Extension Tube for cleaning soil, debris, chips,
feathers and etc.
The Small brush Accessories for cleaning racks, clothes,
electronic devices, lampshades, furniture, curtains and etc.
Round brush for cleaning curtains or dusting.
The hard ground brush for cleaning dust and etc. on the
hard grounds such as parquet.
Hard flooring nozzle for hard grounds.
• Plug in your vacuum cleaner and start it by pressing the
On-Off Button. Adjust the suction power by turning the
On-Off Button.
• After completing the vacuuming process, turn off your
vacuum cleaner by pressing the On-Off Button. Unplug your
vacuum cleaner and furl the cord by pressing Cord Spinning
button. For some models, for furling the cable, it will be
sufficient to hold and pull the cord lightly. This specification
can vary in accordance with the model.
5. CLEANING AND MAINTENANCE
• You have to unplug your device, before beginning any
Cleaning or Maintenance processes.
• After every use, empty the water in the Transparent Water
Tank and clean and dry the tank.
10
• Do not ever leave your vacuum cleaner with liquid and
dirt in it for hygienic purposes and extending the life of your
vacuum cleaner.
• Pull and remove the Water Filter Body and the engine air
inlet neck. The Water Filter Body and the engine air inlet neck
can be washed with warm and soapy water or under tap
water. Dry after you wash these parts before replacing them.
• The cleanness of hepa filter should be checked periodically.
Clean the filter if it is not clean. This filter loses its characteristics after a certain usage period and requires replacing.
• Carry your vacuum cleaner by holding from its Body Handle.
•Just use original parts and accessories for efficient cleaning
and lifecycle and warranty of your device. Provide the
accessories and parts from the closest Authorized Service
when it is required.
WARNING: Only perform dry vacuuming with your
vacuum cleaner.
6. TECHNICAL SPECIFICATIONS
Model: BORA 5000
Voltage: 220-240V~, 50-60Hz
Power: 1200W Max.
Electrical Insulation class: II
Cord Length: 6m.
11
12
13
14
15
16
17
18
19
20
21
22
23
HOUSHOLD CLEANING
BEVERAGE PREPARATION
HOUSHOLD APPLIANCES
IRONS">