MicroSCADA Status Codes is a technical reference manual that lists all MicroSCADA status codes. It provides explanations of the codes and their possible causes, and divides them into groups based on their relation to the base system or communication and NET units.
advertisement
1MRS751251-MEN
Issue date: 29.02.00
Program revision: 8.4.3
Documentation version: A
Copyright © 2000 ABB Substation Automation Oy.
All rights reserved.
MicroSCADA
Status Codes
Notice 1
The information in this document is subject to change without notice and should not
be construed as a commitment by ABB. ABB assumes no responsibility for any error
that may occur in this document.
Notice 2
This document version complies with the program revision 8.4.3.
Notice 3
Additional information such as Release Notes and Last Minute Remarks can be found
on the program distribution media.
Trademarks
Microsoft is a trademark of Microsoft Corporation.
Windows NT is a trademark of Microsoft Corporation.
LON WORKS is a registered trademark of Echelon Corporation.
Other brand or product names are trademarks or registered trademarks of their respective holders
All Microsoft products referenced in this document are either trademarks or registered trademarks of Microsoft
Corporation.
Issue date: 29.02.00
Program revision: 8.4.3
Documentation version: A
Copyright © 2000 ABB Substation Automation Oy.
All rights reserved.
MicroSCADA
Status Codes
Notice 1
The information in this document is subject to change without notice and should not
be construed as a commitment by ABB. ABB assumes no responsibility for any error
that may occur in this document.
Notice 2
This document version complies with the program revision 8.4.3.
Notice 3
Additional information such as Release Notes and Last Minute Remarks can be found
on the program distribution media.
Trademarks
Microsoft is a trademark of Microsoft Corporation.
Windows NT is a trademark of Microsoft Corporation.
LON WORKS is a registered trademark of Echelon Corporation.
Other brand or product names are trademarks or registered trademarks of their respective holders
All Microsoft products referenced in this document are either trademarks or registered trademarks of Microsoft
Corporation.
MicroSCADA Status Codes
Technical Reference Manual
1MRS751251-MEN
ABB Automation
Related MicroSCADA Technology Manuals
The following SYS 500 manuals are published with this software release.
Installation 1MRS751254-MEN
Picture Editing 1MRS751255-MEN
Visual SCIL User Interface Design 1MRS751256-MEN
Visual SCIL Objects 1MRS751257-MEN
System Management 1MRS751258-MUM
The following MicroSCADA technology manuals are published with this software
release.
Connecting L ONW ORKS Devices to MicroSCADA 1MRS751249-MEN
System Configuration 1MRS751248-MEN
System Objects 1MRS751252-MEN
Application Objects 1MRS751253-MEN
Programming Language SCIL 1MRS751250-MEN
Status Codes 1MRS751251-MEN
Technical Reference Manual
1MRS751251-MEN
ABB Automation
Related MicroSCADA Technology Manuals
The following SYS 500 manuals are published with this software release.
Installation 1MRS751254-MEN
Picture Editing 1MRS751255-MEN
Visual SCIL User Interface Design 1MRS751256-MEN
Visual SCIL Objects 1MRS751257-MEN
System Management 1MRS751258-MUM
The following MicroSCADA technology manuals are published with this software
release.
Connecting L ONW ORKS Devices to MicroSCADA 1MRS751249-MEN
System Configuration 1MRS751248-MEN
System Objects 1MRS751252-MEN
Application Objects 1MRS751253-MEN
Programming Language SCIL 1MRS751250-MEN
Status Codes 1MRS751251-MEN
1MRS751251-MEN Status Codes
Technical Reference Manual
MicroSCADA
ABB Automation
Contents
Page
1 Introduction .......................................................................................1
2 Handling Errors .................................................................................3
2.1 Reliability of Data ................................................................................... 3
2.2 SCIL Errors ............................................................................................ 3
2.3 System Messages.................................................................................. 4
2.4 Grouping of Status Codes ...................................................................... 5
3 Status Codes .....................................................................................9
3.1 Reliability of Data ................................................................................... 9
3.1.1OK Status Code............................................................................... 9
3.1.2Almost OK Status Codes ................................................................. 9
3.1.3Common Non-Valid Status Codes ................................................. 10
3.2 Base System Status Codes.................................................................. 10
3.2.1SCIL Syntax Error Codes............................................................... 10
3.2.2Picture Handling Status Codes ...................................................... 26
3.2.3Report Database and REPR Status Codes.................................... 30
3.2.4Process Database Status Codes ................................................... 33
3.2.5NET Interface Status Codes .......................................................... 42
3.2.6Picture Database Status Codes ..................................................... 43
3.2.7PICO MOTIF Status Codes ........................................................... 44
3.2.8Disk File Status Codes .................................................................. 56
3.2.9Video Communication Status Codes ............................................. 58
3.2.10 Printer Spooler Status Codes...................................................... 58
3.2.11 System Status Codes ................................................................. 58
3.2.12 DOS Communication Status Codes ............................................ 65
3.2.13 DECNET Status Codes............................................................... 66
3.2.14 TCP/IP Status Codes.................................................................. 66
3.2.15 Stand-alone Frontend (MFEL) Status Codes .............................. 66
3.2.16 Operating System Status Codes ................................................. 67
Technical Reference Manual
MicroSCADA
ABB Automation
Contents
Page
1 Introduction .......................................................................................1
2 Handling Errors .................................................................................3
2.1 Reliability of Data ................................................................................... 3
2.2 SCIL Errors ............................................................................................ 3
2.3 System Messages.................................................................................. 4
2.4 Grouping of Status Codes ...................................................................... 5
3 Status Codes .....................................................................................9
3.1 Reliability of Data ................................................................................... 9
3.1.1OK Status Code............................................................................... 9
3.1.2Almost OK Status Codes ................................................................. 9
3.1.3Common Non-Valid Status Codes ................................................. 10
3.2 Base System Status Codes.................................................................. 10
3.2.1SCIL Syntax Error Codes............................................................... 10
3.2.2Picture Handling Status Codes ...................................................... 26
3.2.3Report Database and REPR Status Codes.................................... 30
3.2.4Process Database Status Codes ................................................... 33
3.2.5NET Interface Status Codes .......................................................... 42
3.2.6Picture Database Status Codes ..................................................... 43
3.2.7PICO MOTIF Status Codes ........................................................... 44
3.2.8Disk File Status Codes .................................................................. 56
3.2.9Video Communication Status Codes ............................................. 58
3.2.10 Printer Spooler Status Codes...................................................... 58
3.2.11 System Status Codes ................................................................. 58
3.2.12 DOS Communication Status Codes ............................................ 65
3.2.13 DECNET Status Codes............................................................... 66
3.2.14 TCP/IP Status Codes.................................................................. 66
3.2.15 Stand-alone Frontend (MFEL) Status Codes .............................. 66
3.2.16 Operating System Status Codes ................................................. 67
MicroSCADA Status Codes
Technical Reference Manual
1MRS751251-MEN
ABB Automation
3.3 NET Status Codes ............................................................................... 67
3.3.1Common NET Status Codes.......................................................... 67
3.3.2Redundant Frontend Status Codes................................................ 67
3.3.3Errors in Message Structure NET - Basesystem............................ 68
3.3.4Common NET Application Layer Status Codes.............................. 69
3.3.5System Process Status Codes ...................................................... 69
3.3.6NET device errors in NET .............................................................. 70
3.3.7ANSI Station Status Codes............................................................ 70
3.3.8ANSI Station Message SPLIT Status Codes.................................. 73
3.3.9SINDAC ADLP180 Status Codes................................................... 73
3.3.10 SINDAC Status Codes ................................................................ 74
3.3.11 RTU 200 Status Codes ............................................................... 76
3.3.12 RTU 200 Terminal Status Codes ............................................... 78
3.3.13 PROCONTROL 214 Status Codes.............................................. 80
3.3.14 SAT Device Status Codes........................................................... 81
3.3.15 BAG Device Status Codes .......................................................... 82
3.3.16 LCU Device Status Codes .......................................................... 82
3.3.17 PAC Device Status Codes .......................................................... 84
3.3.18 CCT Device Status Codes .......................................................... 84
3.3.19 Printer Status Codes................................................................... 84
3.3.20 SPA Device Status Codes .......................................................... 85
3.3.21 Bit Pad One (BPO) Device Status Codes.................................... 87
3.3.22 REX Device Status Codes .......................................................... 87
3.3.23 LMK Device Status Codes .......................................................... 89
3.3.24 RP570 Slave Status Codes......................................................... 90
3.3.25 Monitor Status Codes ................................................................. 91
3.3.26 ADE Device Status Codes .......................................................... 91
3.3.27 PCO Device Status Codes.......................................................... 91
3.3.28 WESC Device Status Codes ....................................................... 92
3.3.29 Errors in ACP/MDLC Gateway (Motorola) ................................... 93
3.3.30 ATR Device Status Codes .......................................................... 93
3.3.31 PLC Device Status Codes........................................................... 93
3.3.32 IEC Device Status Codes............................................................ 94
3.3.33 Status codes for DNP devices..................................................... 96
3.3.34 NET Network Layer Status Codes .............................................. 99
3.3.35 Common NET Link Layer Status Codes.................................... 101
Technical Reference Manual
1MRS751251-MEN
ABB Automation
3.3 NET Status Codes ............................................................................... 67
3.3.1Common NET Status Codes.......................................................... 67
3.3.2Redundant Frontend Status Codes................................................ 67
3.3.3Errors in Message Structure NET - Basesystem............................ 68
3.3.4Common NET Application Layer Status Codes.............................. 69
3.3.5System Process Status Codes ...................................................... 69
3.3.6NET device errors in NET .............................................................. 70
3.3.7ANSI Station Status Codes............................................................ 70
3.3.8ANSI Station Message SPLIT Status Codes.................................. 73
3.3.9SINDAC ADLP180 Status Codes................................................... 73
3.3.10 SINDAC Status Codes ................................................................ 74
3.3.11 RTU 200 Status Codes ............................................................... 76
3.3.12 RTU 200 Terminal Status Codes ............................................... 78
3.3.13 PROCONTROL 214 Status Codes.............................................. 80
3.3.14 SAT Device Status Codes........................................................... 81
3.3.15 BAG Device Status Codes .......................................................... 82
3.3.16 LCU Device Status Codes .......................................................... 82
3.3.17 PAC Device Status Codes .......................................................... 84
3.3.18 CCT Device Status Codes .......................................................... 84
3.3.19 Printer Status Codes................................................................... 84
3.3.20 SPA Device Status Codes .......................................................... 85
3.3.21 Bit Pad One (BPO) Device Status Codes.................................... 87
3.3.22 REX Device Status Codes .......................................................... 87
3.3.23 LMK Device Status Codes .......................................................... 89
3.3.24 RP570 Slave Status Codes......................................................... 90
3.3.25 Monitor Status Codes ................................................................. 91
3.3.26 ADE Device Status Codes .......................................................... 91
3.3.27 PCO Device Status Codes.......................................................... 91
3.3.28 WESC Device Status Codes ....................................................... 92
3.3.29 Errors in ACP/MDLC Gateway (Motorola) ................................... 93
3.3.30 ATR Device Status Codes .......................................................... 93
3.3.31 PLC Device Status Codes........................................................... 93
3.3.32 IEC Device Status Codes............................................................ 94
3.3.33 Status codes for DNP devices..................................................... 96
3.3.34 NET Network Layer Status Codes .............................................. 99
3.3.35 Common NET Link Layer Status Codes.................................... 101
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
advertisement
Key Features
- Lists all MicroSCADA status codes
- Provides explanations of the codes
- Divides codes into groups
- Covers base system and NET units
- Technical reference manual
Related manuals
Frequently Answers and Questions
What is the purpose of the MicroSCADA Status Codes?
Status codes are used to indicate the reliability of data, inform about errors during SCIL program execution, and communicate events in the process communication system or communication units.
How are status codes grouped?
Status codes are grouped into categories: reliability of data, base system status codes, NET status codes, operating system status codes, data transfer status codes, and status codes transmitted by a NET unit to external devices.
What is the OK status code?
The OK status code is 0, indicating that no error has occurred.
What is the difference between almost OK status codes and error codes?
Almost OK status codes (1, 2, 3) indicate a warning or uncertain value that can be used in expressions but may result in a non-zero status. Error codes (10 .. 10 000) are used for errors in the system.
advertisement